Duco DucoBox Focus Manual de instalación - Página 10
Navegue en línea o descargue pdf Manual de instalación para Campana de ventilación Duco DucoBox Focus. Duco DucoBox Focus 20 páginas.
También para Duco DucoBox Focus: Manual del usuario (2 páginas), Manual de instalación (16 páginas), Inicio rápido (4 páginas)
Imprimir página
ENGLISH
05.B Pairing the control valves
The control valves are paired automatically to the DucoBox whenever 'installer mode' is activated (see "Pairing components" chap-
ter)�
05.C Removing / replacing a control valve
Taking control valve out temporarily
Follow these steps to take a control valve out of the unit
temporarily, e�g� to clean it during maintenance� Take care to
ensure that it is inserted back in the same location� Use the
letter labels on the DucoBox and the relevant valve for this� The
DucoBox will retain all its settings when the control valve is
reconnected�
Permanently removing or replacing control valve
To remove a control valve permanently from the system or to replace it (e�g� in the event of a fault) it is important that it should be
paired correctly� The DucoBox will not be able to be calibrated correctly if this is not done�
Permanently removing control valve
Short-press the valve button in order to drive it shut�
1
Activate 'Installer mode' by pressing 'INST' on the
DucoBox� The LEDs on the DucoBox and control
2
valves will flash green rapidly�
Long-press the button once on the control valve to be
removed in order to remove it from the network� NB:
3
any underlying components will also be removed
from the network.
Disconnect the wiring from the control valve to be
4
removed and slide it out of the DucoBox�
Deactivate 'Installer mode' by pressing 'INST' on the
5
DucoBox� All LEDs will stop flashing�
05.D LED indications
The LED on the control valves will be white or off in normal
operation, depending on the control valve position� The bright-
ness of the LED indicates the flow rate through the valve�
Please refer to "07�B LED indications on page 12 for the
meaning of the remaining LED colours�
10
L2000631 Installation guide for DucoBox Focus (Revision K | 13.07.2020)
Temporarily removing control valve
Short-press the valve button in order to drive it
1
shut for 15 minutes� The LED will go out�
Disconnect the wiring�
2
Slide the valve out of the DucoBox�
3
Replacing a control valve
Short-press the valve button in order to drive it shut�
1
Activate 'Installer mode' by pressing 'INST' on the
DucoBox� The LEDs on the DucoBox and control
2
valves will flash green rapidly�
Short-press the button twice on the control valve to
3
be replaced in order to remove it from the network�
Disconnect the wiring from the control valve to be
4
replaced and slide it out of the DucoBox�
Slide the new control valve into the DucoBox and
5
connect it�
Short-press the button on the new control valve
once� The latter will take on all settings / connec-
6
tions in the network�
Deactivate 'Installer mode' by pressing 'INST' on the
7
DucoBox� All LEDs will stop flashing�
Valve shut
= lowest air flow
LED
Valve open
= max air flow
LED