AnyTone AT-6666 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Radio bidireccional AnyTone AT-6666. AnyTone AT-6666 13 páginas.

INSTALLATION

Choose the most appropriate setting from a simple and practical point of

view. Your radio should not interfere with the driver or crash the driver's

knee or leg when rush brake.

Using the self-tapping screws and pads(2 sets) to fix the bracket.

Put the Non-slip mat on the 2 ends of the bracket and put in the

radio.Then insert the adjusting screws and check carefull each

screws, make sure the screws and machine will not loose when the

car shaking.

Choose suitable angle by the 3 screw holes in the two ends of

bracket.

ANTENNA INSTALLATION

Before using this radio, please install a high efficent and harmonious

adjusted CB antenna, suitable antenna type and correct installation

will bring excellent communication.

To match with the radio, the antenna and cable shall with

characteristic impedance of 50ohm, or the antenna system will not

efficient enough and will disturb TV, radio or other electronics.

Screw the antenna connector into the antenna jack.

Grounding the antenna system to ensure best performance of

this radio.

WARNING:

▲ Connect antenna firstly before transmiting, or it might damage the

radio.

▲ To avoid the risk of fire, electric shock, radio damage, all base

station shall equip of lightning protector

▲ Be sure choose a matching antenna, you may enquiry our dealers.

The position of antenna can be put as following example:

POWER CONNECTION

This radio adopt 13.8V power supply, never connect it to 24V battery,

And the 13.8V car battery shall with sufficient current, or the LCD will

become dark and Transmit power will drop down.

Connect positive red power cable with the + terminal of the battery.

Connect negative black power cable with the - terminal of the

battery.

▲ We suggest not use cigar lighter as it often bring down the voltage.

▲ Locate the power cable away from high temperature,moisture,

portfire and cable insulator.

▲ Use a full power cable even it is longer than need, do not take off

the fuse holder from the cable.