Anywave ATSC 25W Manual de inicio rápido - Página 12

Navegue en línea o descargue pdf Manual de inicio rápido para Transmisor Anywave ATSC 25W. Anywave ATSC 25W 13 páginas. Dtv transmitter

12. Check RF Performance metrics (SNR, LIMD, UIMD) on the front panel screen

of the exciter.

Your TX should now be up and running properly into your load or on-air

antenna. Continue to monitor system parameters as you allow the transmitter to

operate and stabilize at full output power for another 30 minutes.

13. To turn the TX On/Off, please use the RF On/OFF control in the RF submenu

of the exciter LCD or the exciter web interface.

14. For Remote TX Monitoring and Control, you may network to the Exciter

REMOTE RJ-45 rear panel connection at 192.168.1.143 – you can change the

exciter ipaddress by navigating to the CONFIG submenu (simultaneously press

Left and Right buttons) and change the value of IP (please reference your

Exciter User Manual for details).

15. If using the Exciter Built-in remote web interface for remote control, please be

sure to set the Exciter to REMOTE mode (set CTL to RMT) before leaving the

transmitter site. The Remote/Local setting is located under the SYSTEM

submenu. Most of the Local TX controls are available on the remote web

interface, including On/Off, Raise/Lower power, etc. (refer to the Exciter user

manual for details).

ACT-25-QSG-DOC-V1.2, 09/29/2014

ATSC 25W TX Quick Start Guide

Page 12 of 13