Anywave ATSC 280W Manual de inicio rápido - Página 9

Navegue en línea o descargue pdf Manual de inicio rápido para Transmisor Anywave ATSC 280W. Anywave ATSC 280W 13 páginas.

5 Initial Turn On

Please locate and have handy for reference a copy of your 280W TX Factory Test

Report as well as the 280W TX Quick Start Guide, and 280W PA and Exciter

User Manuals.

1. With all equipment turned OFF, please make the cable connections according

to the System Interconnect Diagram of section 4. Make sure the BPF or PA

output is properly connected to your Antenna feed or a suitable station load

before proceeding further.

2. Turn ON the Exciter via its rear panel AC switch.

3. Check Exciter settings. Check the operating Frequency of the Exciter by

navigating to the Exciter FREQ submenu (simultaneously press Left and Right

buttons)

Check the Exciter drive level is set to -25dBm by navigating to the Exciter RF

submenu (from above, press ESC button then enter the RF submenu).

(Please refer to your Exciter User Manual for help with detailed operation of

the Exciter).

4. Turn the 280W PA ON via the PA rear panel breaker, then press the front panel

PA RF On/Off button to turn ON the PA - which should turn BLUE when ON.

5. The built-in FWD and REF power metering in your 280W TX has already been

calibrated at the factory. The Exciter PAC submenu contains the System

Forward and Reflected power meter readings PA_Fwd and PA_Ref. Visit the

PAC menu on the Exciter LCD (under Advanced submenu) or Web interface

ACT-280-QSG-DOC-V1.2, 07/12/2018

ATSC 280W TX Quick Start Guide

Page 9 of 13