Danby DDW1805 Manual de servicio - Página 10

Navegue en línea o descargue pdf Manual de servicio para Lavavajillas Danby DDW1805. Danby DDW1805 15 páginas. Dishwasher division 22 461
También para Danby DDW1805: Manual de servicio (16 páginas), Manual de servicio (12 páginas)

Imprimir página
Danby DDW1805 Manual de servicio
The troubleshooting cheek list is common for all dishwasher models.
They use different parts to accomplish the same thing and diagnosis will
remain similar.
When a problem arises, and a possible cause is listed, follow the test,
remove or replace procedures as outline in this service manual. The
wiring diagram, shematic and timer cycle chat is a necessity when
making electrical checks. In most cases an ohmmeter will handle all the
tests necessary.
For checking any particular cycle of operation, it absolutely necessary
that the cycle be set up as outlined in the product owner's guide.
SYMPTOM
Dishwasher
will
not
operation when turn on
Dishwasher stop washing
but draining
Water can't pour out from
float support when pull
out the rubber cap.
Dishwasher runs but not
heat
Dishwasher will not stop.
Dishwasher
runs
with
door open
Motor hums but will not
start or run.
Motor trips out on in
terminal thermal overload
protector.

TROUBLESHOOTING

CHECK THE
FOLLOWING
●fuse (blow nor tripped)
●Supply line receptacle, wiring
harness.
●Timer (contacts open or burnt).
●Motor
(inoperative,
resistances).
●Door switch (open contacts)
●Door latch not making contact
with door switch.
● Overflow occur.
● Hole in the float supply is
jammed.
●heater element (open).
●Timer contacts (open or burnt).
●Wiring or terminal (burnt or
broken).
● Thermostat is closed.
●Timer motor (inoperative).
●Wiring or terminal (burnt or
broken).
●Timer (open or burnt contact).
●Defective door safety switch.
●Start winding(open).
●Motor (bad bearings or locked
rotor).
●Start relay not dropping out.
●Improper voltage.
●Seal faces binding.
●Motor shaft binding.
●Motor windings shorted.
●Glass or foreign items in pump.
REMENDY
Replace fuse or reset breaker.
Repair or replace.
Replace timer.
check
Replace motor.
Replace door switch.
Replace or adjust to make
contact.
Check the reason of overflow
pull out the rubber cap wait for
a minute let water pour out.
Suck with dust cleaner or other
let water pour out.
Replace heater element.
Replace timer.
Repair or replace.
Replace.
Replace timer.
Repair or replace.
Replace timer.
Replace door safety switch.
Replace motor.
Replace motor.
Replace start relay.
Check voltage.
Repair or replace.
Repair or replace.
Repair motor.
Clean and clear area.