Danby DDW2405BL Manual de instrucciones de instalación - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lavavajillas Danby DDW2405BL. Danby DDW2405BL 13 páginas. Built-in
También para Danby DDW2405BL: Manual de instrucciones de instalación (13 páginas)
Imprimir página
INSTALLATION
INSTRUCTIONS
STEP 2 ADJUST LEVELING LEGS
Adjust to
Installation
Height _
Figure 8
©
J
Measure installation height and dishwasher
height. Extend leveling legs out from the dish-
washer base, 1/4" less than installation height.
STEP 4 INSTALL90o ELBOW
Wrap the 90 ° elbow with thread seal tape, then install
it onto the water valve. To avoid damage to the
water valve bracket and/or fitting,
do not over=
tighten the 90 ° elbow. Position the end of the elbow
to face the rear of the dishwasher.
i
Fill
Hose
J
90°
Elbow
Thread
Figure 11
Seal T ape
Water
Valve
Bracket
STEP 3 Remove Kick Plate
Remove the kickplate screws.
Lift off the 2 piece
kickplate.
2 Kickplate
Screws
Figure9
STEP 5 POSITION WATERLINE AND HOUSE
WIRING
• Position water supply and house wiring on the
floor of the opening to avoid interference with
base of dishwasher and components under
dishwasher.
m
Braided
Watel Line Wiring
Figure 12
m
5