Anzzi ENVO WH-AZ006-M1 Manual de instalación y funcionamiento - Página 11
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Calentador de agua Anzzi ENVO WH-AZ006-M1. Anzzi ENVO WH-AZ006-M1 16 páginas. Electric instant water heater
Imprimir página
INSTALLATION
Step 1:
1. Mark two screw hole locations on the wall where the water heater is going to be placed.
Make sure both holes are vertical and 5.75" (146mm) apart if installing the heater with the
outlet and inlet pointed downward or 5.47" (139mm) if the outlet and inlet pointed upwards.
2. If screw locations are in wall stud, drive mounting screws directly into stud. if screw
locations are not in stud. Drilling two 0.24''(6mm) diameter holes on the wall. Insert the
plastic anchors into the holes and then drive screws into wall anchor.
Step 2:
Heater with the outlet and inlet pointed
downward:
1. Place water heater on wall and slide
onto mounting slot.
2. Secure water heater to wall with screw
through safety tab.
3. Ensure water heater is level and secure
on wall. (Fig 4)
Heater with the outlet and inlet pointed
upward:
1. Place water heater on wall and slide
onto mounting slot.
2. Secure water heater to wall with screw
through safety tab.
3. Ensure water heater is level and secure
on wall. (Fig 5)
Fig 3
Screw mounting Slot
Safety Tab
Safety Tab
Screw mounting Slot
Fig 4
Fig 5
PG.7