Anzzi Envo WH-AZ027-M3 Manual de instalación y funcionamiento - Página 18
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Calentador de agua Anzzi Envo WH-AZ027-M3. Anzzi Envo WH-AZ027-M3 20 páginas. Electric instant water heater
Imprimir página
OPERATION INSTRUCTIONS
CAUTION: Wait until water is fully flowing through the heater before turning on
the breaker.
1. Allow water to flow through the water heater unit. Allow the water to flow continuously to
flush out any debris as well as purge the pipes of any air.
2. Turn on the breaker to power the water heater. An audible beep will be heard and the LED
display will light up for 2 seconds.
3. Press
to turn ON/OFF the appliance. When the unit is ON, the LED will display the water's
temperature. 20 seconds after the flow of water has been stopped the screen will to into
energy saving mode. The unit is still ON and the screen will still light up when a button is
pressed.
Check the product specification page to check minimum water flow for activation.
4. Press
and
from 86-125°F (30-52 ° C).
Caution: If the unit is paused there may be an initial burst of very hot water when resuming.
Please allow the water to flow for a few moments to let the temperature settle. It's always
advised to test the water temperature with your hand before hopping straight into the shower.
5. Press
to convert the temperature display between Fahrenheit and Celsius.
6. The water heater unit will remember and save the previously used temperature on the next
use.
7. There is an over-temperature protection system for this unit. When the temperature reaches
144 ° F (62 ° C) the system will automatically start to decrease the temperature until it's back
to a safe level. Only then will you be able to increase the temperature again.
If the unit will not be used during the winter completely drain out the water to prevent freezing.
●
Periodically clean the water heaters inlet strainer, the faucet's aerator, and the shower's head
●
to ensure free flow of water.
CLEANING & MANTENANCE
ATTENTION
Do not attempt to repair the water heater unit yourself. Please contact a certified professional
●
or call our customer support for assistance. It is important to shut off all power to the water heater
directly at the fuse or breaker. Failure to do so could cause permanent damage to the water
heater and void the product warranty.
Before performing any maintenance make sure to take precaution and prevent exposure to the
●
potentially hot water. The water may be hot enough to present a serious scalding hazard. The
water should be safely drained to prevent any injury or property damage.
It is recommended to regularly maintenance the water heater. Proper maintenance will help
●
lead to a long running, trouble free water heater.
Periodically remove scale and dirt that may build up at the faucet aerator.
●
PG.14
to adjust the outgoing water temperature. The temperature setting ranges