3P Technik 1000500 Instrucciones de uso y montaje - Página 4
Navegue en línea o descargue pdf Instrucciones de uso y montaje para Sistemas de filtración de agua 3P Technik 1000500. 3P Technik 1000500 4 páginas. Rainwater filter for installation into tanks or in the ground
Imprimir página
Installation of the 3P Volume Filter VF1 with the 3P Telescopic Extension:
• Lift the lid off the 3P Volume Filter VF1 and lock the lower part of the 3P Telescopic Extension
tube, using the bayonet socket fitting, onto the 3P Volume Filter VF1. It has to be fully engaged.
• The upper surface of the upper ring collarto the upper section of the Telescopic Tube can be
fitted flush at ground level. This leaves the Volume Filter VF1 lid just proud of the groundsurface
for easy removal and access.
• Push the upper section of the 3P Telescopic Extension on to the lower part until you reach the
required height.
• If the final required height is lower than the minimum with the two pieces, simply cut by sawing
the upper or the lower part with a fret saw to the required height.
• If the final required height is higher than the maximum you can use a second
telescopic extension on top.
• Next, back fill the tube surround with gravel or stone chippings. Compress the back fill below
the upper collar of the upper extension section, so that the collars take the loading, and not the
3P Volume Filter VF1 below.
• If installed in a block built inspection chamber there may be no need for the
3P Telescopic Extension Tube, or it can be fittedto the base of an inspection chamber floor.
Maintenance advice:
The filter requires cleaning regularly. If it is not raining unscrew the lid of thehousing and clean with a
water jet the tray and the filter element. Then remove the filter element. Using a 3 mm Allen key undo
the screwsretaining the filter mesh. Rinse the filter mesh with water. Clean with milddetergent and a
stiff brush, both sides to help dissolve any fatty deposits orhydrocarbon build up. Rinse it again. Do not
use a metal brush which maydamage the filter mesh. You may also put the filter mesh into a dishwasher.
After cleaning examine the filter by holding up against the light and inspectfor any blocked holes in the
filter mesh. If the filter is clean put the filter meshback and re-fix in position.
Recommended Accessories:
3P Removal Handle
Ideal for removal of the 3P Filters
from deeper installations.
Remains in position, length: 500 mm
Item No. 1000550
Öschstraße 14
73072 Donzdorf - Germany
T +49 (0) 71 62 - 94 60 7-0
F +49 (0) 71 62 - 94 60 7-99
www.3ptechnik.com
3P Telescopic Extension
Guarantee:
3P Technik Filtersysteme GmbH offers this product
the guarantee required by law (from date of purchase).
Plastic telescopic shaft for
installation directly into the
ground.
Material: Polyethylene
Item No. 1000560