Addictive audio F300.1 Manual del propietario y de instalación - Página 3

Navegue en línea o descargue pdf Manual del propietario y de instalación para Amplificador Addictive audio F300.1. Addictive audio F300.1 15 páginas. Fleck series amplifiers

Imprimir página

To establish the "safe level".

• Start your volume control at a low setting.

• Slowly increase the sound until you can hear it comfortably and clearly, and

without distortion.

• Once you have established a comfortable "sound level" make a note of this

position and do not go above this setting.

Taking a minute to do this will help to prevent hearing damage in the future.

After all, we want you listening for a lifetime.

Introduction

Your ADDICTIVE AUDIO amplifier has been designed to give you very high

performance, and valuable features, at a very reasonable price. Take the time to

read over this brief set of instructions, and you will get full enjoyment from your

system.

Installation

The quality of the installation will affect system performance and reliability. You

may wish to contact a dealer or professional installer. The amplifier is generally

mounted in the rear trunk area but can be mounted in any convenient area such as

beneath a seat. Please be sure to locate this unit where you have reasonable air

circulation and protection from any moisture.

When considering the mounting location you should minimize the length of the

power supply and speaker leads. Minimizing both leads will provide higher audio

output from the system. It is important to ensure that the heat sink is not against a

panel or a surface preventing air circulation. Mark the location for the mounting

screw holes by using the amplifier as a template. Drill #29 or 9/64" diameter holes

at the marked locations and firmly fasten the amplifier in place with the mounting

screws supplied in the accessory kit.

Before drilling or cutting any holes investigate the layout of your automobile

thoroughly! Take care when working near the gas lines, hydraulic lines and

electrical wiring.

This power amplifier has a protection feature to prevent any damage from misuse

or faulty conditions - excessive heat, short circuit speakers or overload. If the unit

senses one of the above conditions, the protection indicator will light and the

system will shut down. To diagnose the problem turn all levels down, all power off

and check the installation for possible wiring mistakes or shorts. In the event the

amplifier shuts down due to excessive heat under adverse conditions simply allow

time for the unit to cool down at which time, the protection indicator will not light.

Caution

WARNING