Dancutter DC SUPER FLEX Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Cortador Dancutter DC SUPER FLEX. Dancutter DC SUPER FLEX 20 páginas.

5.0 Service and Maintenance

• Always replace the covers on the Cable, Control Unit after

use in order to protect the power connectors.

• Be careful with the compressed air line to avoid dirt getting

into the air supply.

• Avoid water/moisture on the control unit, as it is not splash

proof. Close it after use and hang it on the hose reel to

protect the screen and the switches.

• It is recommended to remove the cover behind the camera

and clean this area, especially after working in downpipes

from below.

Service overwiew

Part - parts - service

Cleaning the cutter

Re-filling with pneumatik oil

Lubricate the ball and piston

Grease in the air motor

Examine parts and tighten or replace them

Clean the tilt function and lubricate with oil

Lubricate the drum shaft with a couple of drops of oil

Refill washer fluid

Replace air filter

• After use, place the cutter in the hose reel so that the air

motor is vertical, so that any moisture formation can drain

out of the air motor and into the hose.

• Only use distilled water or washer fluid on the cutter, as

normal- water will cause lime scale on the valve and sluice.

• Pneumatic oil must be used on the oil lubricator and

MARINE grease in the air motor.

Daily

Weekly

x 13.4

Other

As required