cascade corporation J Series Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica cascade corporation J Series. cascade corporation J Series 18 páginas.

Imprimir página

ERIODIC MAINTENANCE

2000-Hour

After 2000 hours of truck operation, in addition to the

100, 300 and 1000-hour maintenance, forks in use shall

be inspected at intervals of not more than 12 months

(for single shift operations) or whenever any defect or

permanent deformation is detected. Severe applications

will require more frequent inspection.

Fork inspection shall be carried out by trained personnel

to detect any damage that might impair safe use. Any fork

that is defective shall be removed from service. Reference

ANSI B56.1-2005.

Inspect for the following defects:

• Surface cracks

• Straightness of blade and shank

• Fork angle

• Difference in height of fork tips

• Positioning lock

• Wear on fork blade and shank

• Wear on fork hooks

• Legibility of marking

NOTE: Fork Safety Kit 3014162 contains wear calipers,

inspection sheets and safety poster. Also available

is fork hook & carriage wear gauge 209560 (Class II),

209561 (Class III) and 6104118 (Class IV).

Swing and Slope

Attachments

In addition to the previous page maintenance schedule,

where applicable, the following maintenance procedures

must be completed on swing and slope attachments:

• 300 Hours – Apply general purpose chassis grease

to pivot pin zerk fittings and cam rollers.

• 1000 Hours – Inspect swing and slope frame pivot

points for wear.

• 1000 Hours – Inspect wedge bearings (mechanical

swing frame) for wear.

• 1000 Hours – Inspect swing and slope cylinder

pivot pins and clevis pins for wear. Replace part as

necessary.

6082563-R2 EN

Cylinder

Pivot Pins

Cam Rollers

Frame

Pivot Pins

SS0817.eps

Wedge

Bearings