Cascade Health and Fitness FLUIDPro Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Bicicleta estática Cascade Health and Fitness FLUIDPro. Cascade Health and Fitness FLUIDPro 8 páginas. Cascade health and fitness fluidpro fitness bike with wireless power meter
Imprimir página3. Next rotate the roller adjustment knob and associated lock ring counterclockwise so that the roller
assembly allows room for the rear tire to mount.
Lift the bicycle into position so that the rear QR skewer is aligned with the right and left axle clamp cones.
See Figure 3.
a. By turning both the adjustment knob and the release clamp clockwise, tighten the clamp cones until they
come into contact with the bicycle's QR skewer ends.
b. Tighten the adjustment knob and release clamp until the bike is securely held in place and the bicycle's
rear wheel is centered on the roller assembly.
clamp can be opened and closed firmly.
if the lever will not open or close, loosen the adjustment knob by rotating counterclockwise.
•
If the lever is too easy to open or close by hand, tighten the adjustment knob by rotating
•
clockwise.
c. Rotate the locking rings clockwise until they are firm against the frame. Verify the bicycle is securely
mounted to the trainer.
5. Tighten the roller adjustment knob clockwise until the roller contacts the rear tire.
an additional 1½ to 2 full turns.
from slipping while in use.
another 1/4 turn on roller adjustment knob if needed.
will accelerate tire wear.
knob by an additional ¼ turn as necessary to reduce slipping.
Over-tightening will cause both tire and unit damage. Tighten only enough to avoid tire slippage. Use a smooth
tread tire at least 23mm in width and maintain the maximum recommended inflation pressure for your tire.
Once this is set properly tighten the lock ring to the frame.
Riser block.
Use the included riser block to raise the front of the bicycle by putting the riser block under the front wheel.
Figure 2.
Now while holding the bike frame in place test that the release
The release clamp should close firmly by hand.
The roller needs to provide only enough pressure to prevent the rear tire
Test tire friction by quickly moving the tire a 1/4 turn back and forth.
If you notice the tire slipping regularly during use, tighten the roller adjustment
Align the QR skewer with the notch in the clamp cone.
Allowing the tire to slip against the roller while riding
Do not over-tighten the roller adjustment knob.
Then tighten the knob
Apply