Addictive audio 5.2 Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador de coche Addictive audio 5.2. Addictive audio 5.2 13 páginas. Stereo/mono bridgeable high power car amplifier
Imprimir páginaAMPLIFIER MOUNTING
Attention! For your own safety, disconnect the positive battery terminal (+12v) or
remove the main fuse in the positive power cable near the car battery, before you
start any wiring work!
Before you proceed to install this amplifier, it is recommended to map out the complete
audio system and the respective wiring required. Consider all additional electrical
requirements and accessories, such as power cables, interconnect cables etc., to
complete this install. Please note that because of possible interference problems with
the existing car electrics and electronics especially the routing of the signal cables and
the chassis ground connection will have a profound impact on the trouble free
(noise free!) operation of the amplifier.
The mounting location should be carefully selected and in the interest of passive driver
and passenger safety, the amplifier must be securely mounted. Make sure that there is
no wiring harness, fuel tank etc. behind or below the mounting surface, that may be
damaged by the drilling of the holes for the amplifier mounting screws. After installation,
there should be a clearance of at least 5cm to all sides including the top of the amplifier
heatsink. Make sure the unit is not exposed to direct sunlight, humidity, water, oil or spill
of other fluids that may enter the amplifier.
Once the location where the amplifier will be mounted is defined, use the unit as a template
for the marking of the mounting holes with pencil or felt-tip marker. The mounting holes
should be pilot-drilled, using a 2,5mm or 3mm drill bit. For the actual mounting, always
use the supplied rubber washers before attaching the amp to the panel with the supplied
mounting screws.
Self Tapping Screws
- 6 -