3rd Power Kitchen Sink 6VEL Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Amplificador para instrumentos musicales 3rd Power Kitchen Sink 6VEL. 3rd Power Kitchen Sink 6VEL 19 páginas.

Imprimir página

Back Panel (Section Five):

FAN

Tube Effects Loop

Experience STUDIO QUALITY TONE from your pedals or multi-effects units by running them through

the loop. The loop on your Dirty SINK 6VEL can also be placed under foot switch control.

FX Send Jack (26)

This 1/4" mono Tip/Sleeve jack feeds signal to your effects device.

FX Return Jack (27)

This 1/4" mono Tip/Sleeve jack accepts the return signal from your effects device.

FX Loop Operation Switch (28)

Choose LOCAL to retain the loop in the signal chain at all times. Choose FTSW to place the loop un-

der command of your foot switch controller (either the included foot switch or a 3rd party switching

system).

OPERATION NOTES:

• Signal levels at the FX SEND jack are a nominal -10dBV (just under 1V p-p) matching the levels

most vintage and modern effect pedals want to see.

• The FX RETURN path brings your signal back into the ampliﬁer with a tremendous amount of

headroom (accepting signals as low as -10dBV and as high as +4dBU before the onset of com-

pression).

• It can also be a gig-saver too. If your pedal board ever goes down during a performance, you can

plug your guitar straight into the FX RETURN jack and get through a song with quality tone.

CAUTION:

Avoid "hot swap" any cables connected to the loop while the ampliﬁer is operational. Before break-

ing any connections, make sure that your amp is on Standby. Failure to do so may result in a loud

pop, hum or buzz that could potentially damage your speaker.

OHM SELECTOR

16Ω

4Ω

8Ω