Duluth Forge FNVL24-1 Manual - Página 4
Navegue en línea o descargue pdf Manual para Calentador de gas Duluth Forge FNVL24-1. Duluth Forge FNVL24-1 20 páginas. Vented natural gas logs
Imprimir páginaWARNING: Any change to
this log set or its controls can
be dangerous.
WARNING: This appliance is
for installation only in a solid-
fuel burning masonry or factory-
built fireplace, constructed of
noncombustible material, and
connected to a working flue.
WARNING: Keep the appli-
ance area clear and free from
combustible materials, gasoline,
and other flammable vapors and
liquids.
1. This appliance, as supplied, is only for
use with the type of gas indicated on the
rating plate. This appliance is convertible
for use with propane/LP, using the manual
ON/OFF safety pilot valve kit.
2. If you smell gas:
• Shut off gas supply
• Do not try to light any appliance
• Do not touch any electrical switches; do
not use any phone in your building
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions
• If you cannot reach your gas supplier,
call the fire department
3. Never install the log set:
• In a recreational vehicle
• Where curtains, furniture, clothing, or
other flammable objects are less than
42" from the front, top, or sides of the
log set
• In high traffic areas
• In windy or drafty areas
4. Before installing in a solid fuel burning
fireplace, the chimney flue and fire-box
must be cleaned of soot, creosote, ashes
and loose paint by a qualified chimney
cleaner. Creosote will ignite if highly
heated. Inspect chimney flue for damage.
4
SAFETY
5. You must operate this log set with a fire-
6. Do not allow fans to blow directly into the
7. Do not use a blower insert, heat exchang-
8. This log set needs fresh, outside air
9. Do not run log set
10. Do not burn solid fuel in the fireplace after
11. Log set becomes very hot when in use.
12. Carefully supervise young children when
13. Do not use appliance if any part has been
14. To help prevent breakage, new logs must
15. Turn log set off and let cool before servic-
www.factorybuysdirect.com
place screen in place. Make sure fireplace
screen is closed before running log set. If
the fireplace has glass doors, they must
remain OPEN while this log set is in op-
eration.
fireplace. Avoid any drafts that alter burner
flame patterns. Ceiling fans can create
drafts that alter burner flame patterns.
Altered burner patterns can increase
sooting.
er insert, or other accessory not approved
for use with this log set.
ventilation to run properly. See the Air for
Combustion and Ventilation, page 6.
• where gasoline, flammable liquids and
vapors are used or stored
• under dusty conditions
installing the log set. Do not use this log
set to cook food or burn paper or other
objects.
Keep children and adults away from hot
surface to avoid burns or clothing ignition.
Log set will remain hot for a short time
after shut-down. Allow surface to cool
before touching.
they are in the room with log set.
exposed to or under water. Immediately
call a qualified service technician to in-
spect the room appliance and to replace
any part of the control system (if using
control system) and any gas control which
has been under water.
go through the curing process (see Curing
Logs, page 13).
ing, installing, or repairing. Only a qualified
service person should install, service, or
repair log set.
200247-01A