AOG T series Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para parrilla AOG T series. AOG T series 2 páginas. Post outdoor gas grill
También para AOG T series: Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas)
Imprimir página
4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation
in Fig. 4-1:
Vaporizer panels, cooking grids, and warming rack.
Leave pre-installed burners in place to maintain proper alignment.
Vaporizer Panels
Place the vaporizer panels directly onto the studs on the burners.
The panels allow heat from the burners to be evenly directly
throughout the cooking area.
Cooking Grids
Place the cooking grids (over the burners) onto the grid frame.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner's manual to remove or replace.
IMPORTANT: See your grill owner's manual for complete
installation details.
Connect
Screws
Venturi
Fig. 4-2
Read setting
Read setting here
here
OFF
Fig. 5-1 - Burner valve control knob
WHEN OPERATING THIS
GAS APPLIANCE, ALL
INSTRUCTIONS AND
WARNINGS MUST BE
OBSERVED. FAILURE TO DO
SO MAY RESULT IN A FIRE
OR EXPLOSION CAUSING
PROPERTY DAMAGE, BODILY
INJURY, OR DEATH.
6-
Propane
and Natural Gas Safety
IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND
IN YOUR OWNER'S MANUAL. FOR NATURAL GAS READ ALL SAFETY INSTRUCTIONS AND WARNINGS
FOUND IN YOUR OWNER'S MANUAL.
7-Routine Maintenance
Your grill must be serviced and maintained properly to ensure optimal performance, appearance, and safety. The grill must be cleaned
as often as twice a month (depending on use) to prevent grease build-up and other food deposits. See owner's manual for details.
REV 1 - 1804201255
Igniter wire
Air shutter
Replacement parts can be
ordered from your local
Orifice
AOG dealer.
5-Test
Note:
DO NOT turn on more than one valve at a time for either electronic or manual lighting.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
4. Depress the desired control knob, then while pressing turn it counterclockwise to the HI LIGHT
position. Once the burner lights, release the knob.
HIGH to
High to
Note:
Turning the knob will create a "click" sound. The pilot will ignite at this point, lighting the burner.
LIGHT
light
CAUTION:
5. Repeat step 4 for each additional burner to be lit.
Sideburner
control know
(if equipped)
30
"
Cooking Grid
Vaporizer panel
Warming
rack
Sideburner shelf
(if equipped)
Drip tray
If a burner does not light within five (5) seconds of turning on the control
knob, depress the knob and turn it to the OFF position.
MINUTES before repeating step 4. If you smell gas, follow the instructions on
the cover of the grill owner's manual. If the burners still do not light after several
attempts, refer to the grill owner's manual for manual lighting.
Center main burner
control knob
Left
Drip
main burner
tray
control knob
and 36
model controls
"
*
The burner
ports and carry-
over ports must
Main
be kept clean to
*
burner
ensure proper
ignition and
operation.
Backburner
(if equipped)
Rotisserie kit
(if equipped)
Fig. 4-1
WAIT FIVE (5)
Right
main burner
control knob
Backburner
control knob
(if equipped)
Control panel
screw(s)
Fig. 5-2
L-C2-484