dun-bri GROUP Raider 308.R24CR65MAG Manual de inicio rápido - Página 3
Navegue en línea o descargue pdf Manual de inicio rápido para Equipos de iluminación dun-bri GROUP Raider 308.R24CR65MAG. dun-bri GROUP Raider 308.R24CR65MAG 4 páginas.
Imprimir páginaMOUNTING + FITTING INSTRUCTIONS
Carefully unpack and inspect the lightbar and all
accessories before installing to ensure there are no
damaged or missing parts.
Plan all cable routing before attempting installation and
ensure voltage compatibility.
Adjust mounting feet to fit your vehicle.
Mounting location must be a smooth, flat surface to
ensure a secure fitting.
Mount centrally and ensure there are no obstructions
limiting visibility to traffic.
Place and remove the lightbar without sliding, to avoid
damaging the vehicle.
If the lightbar slides or moves easily, a proper installation
has NOT been attained.
MODULE LENS CLEANING
Occasional cleaning is recommended to ensure optimal
light output.
Although tough, polycarbonate scratches easily, so take
care when cleaning.
Clean lens with soap and water or a lens polish using a
soft cloth.
www.dun-bri.com
Dun-Bri Group, Watermill Industrial Estate, Aspenden Road, Buntingford, Hertfordshire, SG9 9JS, United Kingdom
+44 (0)1763 274185
! CAUTION ! - Disconnect the
battery before wiring up the
lightbar to prevent accidental
shorting and/or electrical
shock.
! CAUTION ! - When drilling into
the vehicle surface, make sure
the area is free from anything
that could be damaged,
including any electrical wires,
fuel lines, upholstery, etc.
! WARNING ! - Do NOT attempt
to attach the lightbar to an ice-
covered vehicle.
! WARNING ! - Do NOT exceed
50mph / 80kph when magnetic
mount lightbar is attached. High
speeds could cause
the mount to fail.
! WARNING ! - Do NOT use
solvents as they may damage
the lens.
! WARNING ! - Do NOT use
high-pressure washers or
automatic car washers. This
lightbar is rated IP67.