Dunavox DAB-18.55B Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Enfriador de vino Dunavox DAB-18.55B. Dunavox DAB-18.55B 15 páginas.
Imprimir página
Securely tape down all loose items such as the
shelves inside of the appliance. o Turn the adjustable
foot up to the base to avoid damage. o Tape the door
closed.
Ensure the appliance stays secure in the upright
position during transportation. Also protect the outside
of the appliance with a blanket or similar item.
Power Failure
If power is cut to the appliance, for a few hours it will
be able to maintain the temperature inside the cabinet.
Providing that the number of times that the door is
opened is kept to a minimum.
If the power cut is for longer than a few hours, then
you will need to store the contents in an alternate
location
to
prevent
temperature rise.
IMPORTANT: If the appliance is unplugged, the
power is lost or turned off you must wait 5 minutes
before restarting the Wine Cooler. If you attempt
to restart before this time delay, the compressor
could be damaged.
Vacation Time
Short vacations:
operation for holidays of less than 3 weeks.
Long vacations
: If your appliance is not going to
be in use for a period of time, you should remove the
bottles of wine and switch off the appliance
The interior should be cleaned with a solution of
bicarbonate of soda and lukewarm water.
The
interior
should
thoroughly dried.
To prevent mould growth, the door
should be left slightly ajar.
Disconnecting From Power
If the unit is unplugged, or there is a power cut, you
must wait for 5 minutes before restarting. Attempting
to restart the Wine Cooler before 5 minutes has
elapsed, may cause it not to function.
INSTALLATION
MPORTANT: Before installation and usage read all
the instructions and make sure that the voltage (V)
and the frequency (Hz) indicated on the rating
plate are exactly the same as the voltage and
frequency in your home. The rating plate can be
found on the front left edge of the inside of the
Wine Cooler.
them
being
affected
Leave the Wine Cooler in
then
be
The manufacturer declines all responsibility in the
event of the installer failing to observe all the accident
prevention regulations in force, which are necessary
for normal use and the regular operation of the electric
system.
Electrical Connection
qualified electrician, who is a member of the
by
N.I.C.E.I.C. and who will comply with the I.E.E. and
local regulations.
Positioning
Climate
classification
SN
N
ST
T
• It is advisable that your appliance is only installed in
a location where the ambient temperature of the
room, corresponds with the climate classification that
is stated on the rating plate of your appliance. Your
appliance may not function correctly if the ambient
temperature falls outside of the following ranges.
• Positioning the appliance requires two people in order
to avoid injuries or damage to the appliance.
• Your appliance should not be located in direct sunlight
or exposed to continuous heat or extremes of
temperature (e.g. next to a radiator or boiler). If this is
not feasible, then you should install an insulation plate
between the appliance and the adjacent heat source.
• You should check whether there is an electrical socket
available, which will be accessible after your appliance
is installed. o Place the appliance flatly and firmly on a
solid base.
• Anything positioned above the appliance must be at
least 10 cm away to allow sufficient cooling of the
YOUR Wine Cooler IS
INTENDED FOR
FITTED AND
PERMANENT
INSTALLATION.
We recommend that
the
appliance
connected
Appropriate ambient
temperature
10 - 32 °C (50ºF-90ºF)
16 - 32 °C (61ºF-90ºF)
16 - 38 °C (61ºF-100ºF)
16 - 43 °C (61ºF-109ºF)
is
by
a