Dunavox DAUF-40.138SS Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Enfriador de vino Dunavox DAUF-40.138SS. Dunavox DAUF-40.138SS 15 páginas.
Imprimir página
DESIGN 3 – For tall models
1. Remove the bottom hinge
the four lock screws
door firmly after removing the screws.(Fig. 1)
2. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then remove
the right top hinge
3. Pop out the cover caps on the left side of cabinet
and use them to
cover the screw holes on the right
hand side.
4. Screw the alternative left top hinge
included in the fittings,
cabinet. (Fig. 4)
5. Unscrew and transfer door supporter
opposite side. At the same time remove the
○
stopper pin
,7 of bottom hinge to the opposite
designated position or unscrew and transfer the
○
hinge pin
of bottom hinge to the opposite
,7a
designated position. (Fig. 5 & 3)
6. Unscrew and transfer the door adapter
○
lock catch
,4 to the top designated position of
glass door. (Fig. 2)
7. Rotate the door 180° and relocate the glass door
to the designated position.
bottom hinge on the left designated position and
tighten it. (Fig. 5)
8. Recheck and adjust the door alignment by
loosening the screws
○
adapter
,5. Tighten the screws
door is levelled. (Fig. 5)
○
,1 by unscrewing
○
,2. Be careful to hold the
○
,9. (Fig. 4)
on the left hand side of
○
,10 to the
○
Then screw the
○
,6and moving the door
○
,6 after the
OPERATING YOUR APPLIANCE
This appliance is designed for operation at certain
ambient temperatures. The climate class is specified
on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme cold
or hot conditions may cause interior temperatures to
fluctuate. The range between 5ºC and 20ºC (41ºF and
68ºF) may not be reached.
Climate class
SN
N
ST
T
NOTE:
internal temperature if the ambient temperature where
the unit is located is lower than the set temperature.
NOTE:
•
○
,8 ,
•
USE AND CONTROL
(
DAU-17.58DB, DSS, DW, DAU-19.58B, SS, W; DAU-
40.138B, SS; DX-94.270DBK, SDSK; DX-143.468B, SS;
DX-166.428DBK, SDSK; DX-170.490TBK, STSK; DX-
,5 and
181.490DBK, SDSK; DX-194.490B, SSK
CONTROL PANEL
For Single Zone
Ambient room temperatures
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Units with no heater will not raise their
When you use the appliance for the first
time or restart the appliance after
having been shut off for a long time,
there could be a few degrees variance
between the temperature you select
and the one indicated on the LED
readout. This is normal and it is due to
the length of the activation time. Once
the unit is running for a few hours
everything will be back to normal.
If the unit is unplugged, power lost, or
turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt
to restart before this time delay, the unit
will not start.
)