Dunavox DAUF-9.22SS Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Enfriador de vino Dunavox DAUF-9.22SS. Dunavox DAUF-9.22SS 13 páginas.

Imprimir página

Locate the handle ① over the fixing pins ③ of the

door and using the supplied allen key, tighten the

securing grub screws ② to fix the handle.

DESIGN 2 –

Remove the door gasket ① on the side you

wish to install the handle - you can see two

designated holes for handle installation.

Install the handle ④ tightly as shown above with

two screws ③ and flat washers ② provided.

Install the door gasket.

Note: All parts removed must be saved to do

the reinstallation of door.

REVERSING THE DOOR HINGE

It is possible to reverse the door on this appliance, if

required.

To do so, follow the steps below:

DESIGN 1 – For built-under models

① Lock screws ② Lower hinge (Right)

③ Door axis ④ Top hinge (Right)

⑥ Cabinet ⑦ Top hinge (Left)

⑧ Lower hinge (Left)

1. Unscrew the Lock screws①. (Fig.1)

⑤ Door

2. Pull the door ⑤outward，take it out. (Fig.2)

3. Unscrew 3 pcs bolts，take out the Top hinge

(Right)④. (Fig.3)

4. Fix the Top hinge (Left) and Lower hinge (Left)

with bolts on the position as picture shows. (Fig.4)

For bar handle:

To rotate door at 180 degrees, then assemble the

door as per the reverse way of remove. (please see

Fig.4)

For other handle:

Install the door as per reverse way of remove.

(please Fig.4)

DESIGN 2 – For tall models

①Upper hinge ②Hinge shaft ③Hinge buckle

④Upper hinge ⑤Lower hinge ⑥Glass door

1. As shown in Figure 1, use a flat-blade screwdriver

to open the upper hinge buckle ③ to see the hinge

shaft ②, and then use a flat-blade screwdriver to pry

the hinge shaft ② and take it out. Then unscrew the

lower hinge in the same way.

2. As shown in Figure 2, the installation method of the

upper part of the door is the same as the lower part.

3. When the upper and lower parts are removed, pull

the door parallel to the outside. The door can be

taken out.

4. Remove the glass door, use the hex wrench to

remove the upper door hinge and the lower door

hinge mounting screws, and remove the upper and

lower door hinges.

5. Pay special attention to this: 1) The glass door is

turned 180 degrees to install, and the lock hook and

magnet of the door are removed and reinstalled to

the other side. 2) The upper hinge and lower hinge

are also exchanged at the same time.The right upper

hinge is changed into the left lower hinge. The right

lower hinge is changed into the left upper hinge.

Becomes the lower door hinge, and becomes the

upper door hinge when the right lower door hinge is

changed to the left side;