Dunbier Brisbane Manual del usuario - Página 17

Navegue en línea o descargue pdf Manual del usuario para Equipamiento náutico Dunbier Brisbane. Dunbier Brisbane 20 páginas.

Fitting Boats To The Trailers.

SupaRolla & Alloy Series, Suits both Fibreglass and Aluminium Boats:

Set the boat on the trailer with all cradles down except the front and rear sets, then adjust each individual set up with a jack under the

leg until they are just firm on the hull. All the inside wobble rollers should be as close to the keel as possible, with the outside rollers to

be on the far outside of a strake. Every roller should be touching the hull and be clear of any strakes built into the hull.

Glider Series and Glider Alloy Series

Setup boat on trailer with all weight on the keel rollers. Roller assemblies or skids are to be setup on the outside of boat chines to aid

in centering the boat retrieval.

AFTER FULL TRAILER ADJUSTMENT YOUR BOAT DOES NOT COME UP THE TRAILER STRAIGHT.

If all skid pads or roller measurements are correct. Then check that the boat sits horizontal in the water, even a very slight lean will

bring the boat up to one side. Move fuel tanks, fishing gear etc, to bring the hull horizontal to the water.

Note: Full multi-roller trailers have a 50mm retrieving tolerance of either side of the centre line of the trailer and this depends on the

boats strakes where they are positioned.

16.