Danfoss FP975 Manual de instalación - Página 7

Navegue en línea o descargue pdf Manual de instalación para Termostato Danfoss FP975. Danfoss FP975 16 páginas. 7 day electronic programmer with separate outputs for heating & hot water, which can be set at independent times.
También para Danfoss FP975: Manual del usuario (16 páginas), Instrucciones de uso (2 páginas)

Imprimir página

IMPORTANT NOTE

If the timeswitch to be replaced is listed below it may be worth

considering a FP715 Si as an alternative to the FP975. The FP715 Si

oﬀ ers wallplate compatibility for those models listed below, although

some re-wiring may be required.

MAKE

ACL

Drayton

Landis & Gyr RWB 2, RWB 2-9, RWB 200, RWB 252, RWB 20, RWB 40

Glowworm

Potterton

If the new unit is replacing an existing time control having an

incompatible wiring conﬁ guration, then the wiring conversions

(tables A and B, pages 12-15) will be of assistance.

4. For wiring connections please refer to diagrams on pages 9-10.

Please note, the FP975 does not require an earth connection,

although a terminal is provided for earth continuity purposes.

5. Ensure that the two retaining screws on the top of the timeswitch

are fully unscrewed. Locate the retaining lugs on the bottom

inside surface of the plug-in module under the wallplate base and

hinge the unit upwards until the module is pressed fully against

the top of the wallplate. Tighten the two screws on the top of the

module to secure the module to the wallplate.

6. A small blanking plug is supplied to blank the unused recessed

bottom ﬁ xing screw.

7. Before setting the programmes the unit should be RESET by

pressing the recessed button marked R/S. Ensure the mains

power to the control circuit is switched on, and check the circuits

as follows.

8. Use the

switch the hot water output ON. Adjust the cylinder thermostat

and check the service operates correctly. Use the SELECT button

to get to OFF mode and check that the service does not operate.

9. Use the

switch the heating output ON. Adjust any remote thermostat(s)

and check that the service operates correctly. Use the SELECT

button to get to OFF mode and check that the service does not

operate.

Danfoss Heating

For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - [email protected]

MODELS

LS2411, LS522, LS722, LP241, LP522, LP722

Tempus 3, Tempus 4, Tempus 7

Mastermind

Mini-Minder

(Hot Water) SELECT button to get to the ON mode to

(Heating) SELECT button to get to the ON mode to