Danfoss DHP-A Manual de instrucciones de instalación - Página 7
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Unidad de control Danfoss DHP-A. Danfoss DHP-A 15 páginas. Outdoor unit
También para Danfoss DHP-A: Instrucciones de instalación (6 páginas)
Imprimir página
2.1.4
Additional label: DHP-AQ Control Maxi 6–13 SP
This label will ensure that this product conforms to the requirements
of United Kingdom Building Regulations and EN12897:2006.
The information is entirely valid in a UK specific installation.
Weight when full
PT valve replacement no.
Oper. temp non self-reset. thermostat
Maximum flow temperature
Operating pressure heat source
Primary heating power input
Primary flow rate
Actual capacity
Standing heat loss
Maximum water supply pressure
Pressure reducing valve
Expansion valve
Expansion vessel charge pressure
Operating pressure
Temp and pressure release valve
Maximum primary working pressure
Immersion heater
WARNING TO THE USER
a) Do not remove or adjust any component part of this
unvented water heater. Contact the installer.
b) If this unvented water heater develops a fault, such as a flow
of hot water from the discharge pipe,
switch the heater off and contact the installer.
WARNING TO THE INSTALLER
a) This installation is subject to Building Regulations notification.
b) Use only appropriate components for installation and maintenance.
c) INSTALLED BY:
Name.______________________________________
Address.____________________________________
Tel No._____________________________________
Completion date._____________________________
286 kg
086U8267
88˚C
65˚C
1 bar
9 kW
0,16−0,31 l/s
180 liter
1,8 kWh / 24 h
10 bar
3 bar
6 bar
3 bar
5,5 bar
10 bar; 90−95˚C
1,5 bar
D76 / 9 kW / 230 V
Appendix UK – 7