Danfoss Weatherhead COLL-O-CRIMP T-480 Manual de instalación y funcionamiento - Página 9
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Bomba de agua Danfoss Weatherhead COLL-O-CRIMP T-480. Danfoss Weatherhead COLL-O-CRIMP T-480 14 páginas.
Imprimir páginaT-480-AH Set-Up & Operating Instructions
1. Pump reservoir must be properly vented
before operation. Release the pusher clip
and slide pusher back. NOTE: Periodically
lubricate the die ring with Weatherhead
T-400-G lubricant. When crimping with
Coll-O-Crimp® I tooling, insert the T-420-25
adapter die ring into the base plate. Insert
the proper sized collet.
4. Holding uncrimped hose assembly in place,
refer to the PowerSource crimp spec tool at
danfoss.com/crimp for correct spacer ring.
Note: when crimping spiral-reinforced hose
(H430, H439, H470), a T-480-68 spacer ring
must be used to prevent damage to the
pusher. Position spacer ring on top of collet
with proper side of spacer ring facing up as
shown in figure B, page 12 and slide pusher
forward, making sure pusher clip has locked.
9 | PORTABLE COLL-O-CRIMP® Model T-480 Set up and operating instructions | 2022.10.
2. Select the proper Weatherhead hose
and end fitting. Insert the hose into the
end fitting, making sure that the hose is
bottomed in end fitting. For insertion depth
information, reference figure A, page 12.
5. Attach air supply and depress pressure valve
and hold until spacer ring contacts the base
ring, indicating that the crimp is complete.
3. Loosen knob and tilt press as necessary.
Insert hose assembly from below the base
plate and between the collet halves. Align
dimples or knurl band on end fitting with
top of collet, making sure that collet halves
are evenly matched. When crimping H757
hose, position end fitting as shown in figure
D, page 12.
6. Release pressure valve to retract pusher.
Release the pusher clip and slide the pusher
back to access tooling. Remove the spacer
ring and the crimped hose assembly from
below the base plate and between the collet
halves.
!
NOTE: Visually inspect the crimped end.
Check nominal crimp diameter and verify that
the crimp is within 1/16" from the locating
dimples on the collar, see figure C, page 12.
BC425482205281en-000101