Danfoss VLT 5000 Manual - Página 3

Navegue en línea o descargue pdf Manual para Media Converter Danfoss VLT 5000. Danfoss VLT 5000 7 páginas. Frequency converter
También para Danfoss VLT 5000: Nota de aplicación (16 páginas)

Imprimir página

The VLT frequency converter is now set up and the

program can be downloaded to the PLC master.

This is done by clicking with the right mouse button

on the Controller board.

Select Parameterization and Execute.

After the parameterization is done, the master will

start to run. If you are using a Siemens S7 or S5

master, the LCD will look like this:

MN.50.U1.02 - VLT is a registered Danfoss trademark

VLT

5000 and Interbus CMD

Drivecom profile

VLT 5000 has implemented the Drivecom profile in

the Interbus software. In order to be able to run with

the Drivecom profile, VLT parameter 512 Telegram

profile must be set to Fieldbus option.

If you change the operating state from Online to

Monitor you can write the control word and refe-

rence to the VLT frequency converter. In Monitor

state you can also read and write to parameters.

Now you can start the built in Drivecom monitor in

CMD by clicking on the Controller board and clicking

on the right mouse button. Select Drivecom.

The Drivecom monitor will now show Danfoss, VLT

5000, Profile: 21, in the upper left corner.

The Drivecom monitor is spilt up in three parts:

Analog Display, Control Word and Status word.

In the Analog Display part you can set a reference

and in the Control word part you can start and stop

the VLT frequency converter. In the Status word

part you can see the actual status word from the

VLT frequency converter.