AudioControl D-4.800 Manual de inicio rápido - Página 10
Navegue en línea o descargue pdf Manual de inicio rápido para Amplificador AudioControl D-4.800. AudioControl D-4.800 17 páginas. High power multi channel amplifier with dsp matrix processor
También para AudioControl D-4.800: Manual de inicio rápido (18 páginas)
Imprimir página
Installation
Installation
We recommend mounting the D-4.800 in the trunk/boot or cargo
area of the vehicle. An alternative location would be under the front
seat of your vehicle if there is enough room to install and also to reach
the controls. When choosing a location, please keep these things in
mind:
1. Before you start, disconnect the +12V positive and negative
cables from the battery in the vehicle to prevent any damage to
the vehicle or the amplifier during the installation process.
2. Pick a mounting location that will provide access to the controls
and connections, provide adequate ventilation, and also protect
the unit from heat, moisture, and dirt.
3. The D-4.800 needs to be securely mounted using the four
mounting holes located in each corner.
4.
Before drilling any holes, take every precaution to prevent
damage to fuel lines, power and other electrical wiring,
hydraulic brake lines, and other systems, that might compromise
vehicle safety.
5. Always mount the unit as far from the antenna in the vehicle
as possible, and away from the radio or any other RF sensitive
electronics in the vehicle.
6. Use between 8 and 3 gauge insulated power cable to connect
the +12V terminal of the D-4.800 to the positive terminal of the
vehicle battery.
7. Use between 8 and 3 gauge insulated cable to connect the
ground terminal of the D-4.800 to the negative terminal of the
vehicle battery.
8. The D-4.800 has speaker-level inputs that are designed to ac-
cept amplified, speaker-level signals from a factory source unit
or amplifier. You may need to refer to a factory service manual
or wiring-harness schematic to determine which wires are the
speaker wires for your system. If you are unsure which are the
speaker wires, we recommend you look at the color of the speak-
er wires connected to the speakers and follow them back to the
source. Connect the speaker wires to the D-4.800 speaker-level
input plugs using the correct polarity.
9. Line-level audio signals will generally come from your after-
market radio, or if you are really getting the most out of your
car audio system they may be coming from a really awesome
product like the AudioControl LC6i (shameless plug). There are
generally only two things to consider when using the line-level
RCA inputs:
1. Use good shielded or twisted pair RCA cables.
2. Run your RCA cables at least 18" away from power and speaker
cables to avoid picking up radiated noise in your system.
10
Quick Start Guide