AudioControl LC6 Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Media Converter AudioControl LC6. AudioControl LC6 16 páginas. Six channel line output converter
Imprimir páginaTROUBLESHOOTING
No Power: If the Power LED on your LC6 will not turn on, check to
make sure that the power wire and remote turn on wires are connected or
a fuse has not blown, and there is plenty of signal present.
LC6 Turns Off Intermittently: If you are using signal sensing to turn
on your LC6 and your head unit has signal-level output, your LC6 may
turn off. In these situations it is recommended that you connect 12-volt
trigger wire from the "Remote In" on the LC6 to a 12-volt switch wired.
Sounds Distorted: Should your system sound distorted or your
speakers are moving way too much, you should make sure you have your
levels matched properly and that your amplifier gains are set at mini-
mum.
System Hiss: Check to make sure that your amplifier gains are set at
the minimum level.
Low Output: Depending on the design of your factory-installed
system, you may actually be connecting to a pre-amp signal instead of a
speaker-level signal. Since the LC6 is a line output converter you may
need to turn up the gains on the LC6 or consider adding a pre-amp line
driver like the AudioControl Matrix to increase the signal level to your
aftermarket amplifiers.
Maximized LED Does Not Light Up: If your system is playing music
but the Maximized LED is not coming on, there is a good chance that the
output voltage of your source unit is not that high. Try increasing the
level control on your LC6.
IF YOU LIKE LC6, YOU'LL LOVE...
The EQS, six-channel
equalizer, is the perfect
trunk mount processor for
those of you who want to
improve the sound and
detail of your vehicle.
Less than ideal factory
speaker locations can
make even the best
speaker systems cry out for help. The equalization controls on the EQS
provide you with an ideal amount of tone control to tame even the most
challenging acoustical situations.
page 12