AudioControl LC6i Manual - Página 5

Navegue en línea o descargue pdf Manual para Media Converter AudioControl LC6i. AudioControl LC6i 16 páginas. Six channel line output converter

A Guided Tour of the LC6i

Speaker-level Inputs: The LC6i has three sets of speaker-level in-

puts. These inputs get their signals from the speaker-level outputs of your

factory-installed source unit or ampliﬁer (if your vehicle is so equipped).

If your source unit has front, rear, and subwoofer speaker-level outputs,

connect them to the three sets of inputs on your LC6i. If the source unit

only has front and rear inputs, the Auto Mode circuitry in your LC6i

automatically routes the Channel 2 input channels to the Channel 3.

Ground: Connect to a good, veriﬁed chassis ground (the battery

②

comes to mind.) Warning: Factory ground wires typically already have

multiple devices connected to them and are not recommended.

+12 Volt: Connect to a good source of power (the battery comes to

mind again)

Remote In: Allows your LC6i to be turned on remotely with a 12-

volt signal.

Remote Out: Outputs 12 volts when the LC6i is powered up so you

can turn on external devices like signal processors and external ampliﬁ-

ers. DO NOT USE FOR SYSTEM POWER!!

Maximized Indicator: This brightly colored LED indicates when

your signal level is just below clipping your LC6i. When properly level

matched, this LED should ﬂicker occasionally when your system is play-

ing at its maximum volume level.

Power: If you have connected all of your power wires correctly,

this light should be bright red when your system turns on.

Remote Subwoofer Level Control Input: This input allows you to

add an optional (sold-separately-not-included) remote that will allow you

to control the subwoofer output of your LC6i from your dashboard.

Pre-Amp Outputs: These RCA connectors should be connected to

the next component after the LC6i, such as a signal processor, crossover

or ampliﬁer. Do not connect any speakers directly to your LC6i. (Deﬁ-

nitely don't connect to any home appliances, like your microwave.)

Level Controls: These knobs allow you to adjust the signal level

from your source unit to match that of your aftermarket ampliﬁers. Be-

cause they are ampliﬁed, most factory-installed source units have rela-

tively high signal voltage output, which will require you to decrease the

signal level.

Channel Summed Indicators: Under the cover of your LC6i are

jumpers that will allow you to sum selected channels into the main chan-

nels. This is especially useful for factory-installed systems with actively

crossed-over speaker systems. These indicator LED's let you know

which channels are being summed into the main inputs.

page 5