Audiodesign PRO PAMX2.102 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Mezclador de música Audiodesign PRO PAMX2.102. Audiodesign PRO PAMX2.102 6 páginas. Professional mixers

Imprimir página
MIXER PROFESSIONALI
MONO CHANNELS
1.
MIC: XLR balanced microphone input for dynamic and capacitor
microphones. By means of the XLR connector, it's possible to feed
condenser microphones. Operate button "PHANTOM ON" to activate this
Mic 1
Mic 1
function ( located on the rear panel) This function is monitored through the
red LED switch on + 48 V located over the LED level indicators. Use of
Bal
dynamic microphones with phantom power supply is generally not
or
Unbal
recommended. *
2.
LINE: balanced or unbalanced line level input , 6,3 mm. Jack
LINE IN
Low Cut
connector.
75 Hz
18 dB/Oct
Important: DON'T use MIC and LINE input signal at the same time
!!!! *
3.
This switch activates high-pass filter at 75 Hz - 18dB/Oct
+10
+10 - 40
+60
TRIM dB/dBu
4.
TRIM: To adjust channel input level.
Should always be completely turned counter clockwise during connection
EQ
0
of any source
HIGH
5.
EQ HIGH: This control adjusts +/- 15 dB with a "shelving" curve
12 KHz
- 15
+15
shape
0
at 12 kHz.
MID
2.5 KHz
6.
EQ MID: This control adjusts +/- 15 dB with a band center at
+15
- 15
2.5 kHz.
0
7.
EQ LOW: This control adjusts +/- 15 dB with a "shelving" curve
LOW
shape at 80 Hz.
80 Hz
+15
- 15
8.
AUX: This control adjusts the output signal level
AUX
0
AUX SENDS 1, controlled through general adjustment (18). This signal is
normally "post" FADER but could become "pre" FADER by operating the
- ¥
+ 15
button (9)
0
9.
This button operates the pre/post FADER level of the AUX control
PRE
FX
10.
FX: This control adjusts signal level to send to AUX SENDS 2 and
to DSP, controlled through general adjustment (19). This signal is always
- ¥
+ 15
"post" FADER
11.
PAN: It adjusts the stereo scene by adjusting the signal levels to
PAN
send to right and left outputs.
Left
Right
12.
MUTE: This dual-purpose switch turns off the channel and sends at
1
MUTE
the same time a signal to an alternative mixing (ALT 3/4 ). Function is on
ALT 3-4
MUTE
when yellow LED lights up.
10
13.
CLIP: The red LED is dual-purpose too: it indicates "SOLO"
CLIP
function (See point 14) or indicates CLIPPING mode.
0
Important: in case LED lights up indicating clipping mode, operate by
SOLO
reducing the TRIM
10
14.
SOLO: This button sends the signal to PHONES and CONTROL
15
ROOM OUT outlets and allows you to hear signals through your
20
headphones and view signal on LED level indicators. Operating the
30
40
"MODE" switch of the main section, it's possible to choose pre or post
60
FADER signal.
15.
FADER: It adjusts the level of the channel signal.
Fig 1
* See connection scheme on page 7
PAMX2
Serie
4
MIXER PROFESSIONALI
SCHEMA A BLOCCHI
PAMX2
Serie
9