Conquip SA800-02100 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Soplador Conquip SA800-02100. Conquip SA800-02100 14 páginas.

Original Working Instructions

Usage Instructions

Pre-Use Checklist

1. Before using the Powerbrush, charge the battery by inserting the 110v plug

into the socket. Once fully charged, remove the plug from the socket.

2. Ensure the water tap is in the 'off position' before attempting to fill the water

tank.

3. Remove the water tank cap, fill the tank with water and replace the cap.

4. Check that the wheels of the Powerbrush are free to swivel, not damaged

and the bearings are well greased.

5. Check the hydraulic hoses and connections for leaks and ensure they are not

damaged.

6. Check there are 2 fork retaining pins in the heel pin storage slots that can be

secured after the telehandler has inserted the forks into the fork pockets.

7. If you have a kerb brush fitted, check the adjustment chain is in its bracket

and the linch pin is secure.

Setting up the Powerbrush

1. To connect the Powerbrush to your forklift, set the machine's forks to the

correct width for the Powerbrush fork pockets. Make sure that they are

equidistant from the centre.

2. Drive the forklift/ telehandler to the Powerbrush. Align the forks with the

Powerbrush fork pockets and fully insert the forks.

3. Fit the fork retaining pins behind the heel of the forks to secure the

Powerbrush to the machine.

4. Apply the park brake and switch off the forklift engine.

5. Release any pressure in the auxiliary hydraulic line of the machine by

operating the control lever.

6. Detach the main hose couplings on the Powerbrush and connect them to

the 2 outputs on the machine. The quick release female on the Powerbrush

connects to the male on the machine and the male to the female.

7. Check that the main brush is rotating and the hopper is opening and closing

fully.

User Guide - Powerbrush

Scan for video guide!

8. Ensure that the main brush is adjusted correctly. Always set up the

Powerbrush on a level surface. The bristles should be touching the ground

very slightly with a small deflection where they meet the floor.

9. To adjust the brush, undo bolt 'A' on one side of the brush (see diagram

below) and apply a small amount of pressure to push the brush to the

ground. Re-tighten the bolt. Repeat this procedure to the other side of the

brush.

10. The Powerbrush is now ready for use.

NOTE: Configuration may differ on different forklift makes and models.