DANLERS TLSW A20 ILM Notas de instalación - Página 2

Navegue en línea o descargue pdf Notas de instalación para Interruptor DANLERS TLSW A20 ILM. DANLERS TLSW A20 ILM 2 páginas. Plated time lag switches (3-wire versions)

Imprimir página
Installation procedure
1. Please read these notes carefully before commencing work.
In case of doubt please consult a qualified electrician.
Make sure the power is isolated from the circuit.
If a four lug metal back box is to be used, the top and bottom lugs
must be removed
2. The TLSW Ax20 (ILM) has two terminal blocks on the reverse, which
should be connected as:
Block 1
L
Live input
N
Neutral input
SL
Switched Line output
Block 2
Push Button For connection to slave switch(es).†
Must not be connected to the mains.
3. Existing two-way strapper lines can usually be used to connect
these time lag switches in parallel or to connect slave switch(es),
as shown in the wiring diagrams opposite.
4. The time lag is adjusted via a spindle (see illustration below) by
inserting a narrow (flat) screwdriver through the hole located on
the bottom edge of the device:
TLSW A20 (ILM)
APPROXIMATE
SETTINGS
10 mins
2
mins
mins
TIME
Notes:
†The two terminals on DANLERS slave switches are labelled as:
Plated Slave switches:
Grid Slave switches:
If grid slave switches are used with plated time lag switches, the
L and S terminals must be connected only to the Push Button
terminals on the timelag switch, not to live.
TLSW A120 (ILM)
APPROXIMATE
SETTINGS
60 mins
20
12
mins
TIME
Push Button
L, S
Typical wiring diagrams
1-way TLSW x20 (ILM)
L
230 VAC
N
Example of a typical 2-way circuit
Multi-way TLSW x20 (ILM) with slave switches
Unused existing wire
terminate safely
120
mins
Multi-way TLSW x20 (ILM) in parallel
TLSW x20 (ILM)
L
SL
N
Push
Button
Push button
SS 1SL
Push button
SS 1SL
Slave
Slave
Switch
Switch
L
SL
SL
L
TLSW x20
TLSW x20
N
N
N
(ILM)
(ILM)
Push button
Push button
load
load
N
L
230 VAC
L
SL
TLSW x20
(ILM)
N
load
N
L
230 VAC
L
SL
TLSW x20
(ILM)
Push button
load
N
L
230 VAC