Audionet AMP III Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Amplificador Audionet AMP III. Audionet AMP III 11 páginas. Three channel power amplifier
También para Audionet AMP III: Manual del usuario (16 páginas)

Imprimir página

Operating

Power

Please, at first turn down your preamplifier. Then bring the main switch

at the rear in the "on" position. The switch is located above the mains

socket. Now the AMP III is in stand-by mode.

For switching your AMP III on and off, please use the power button at

the front panel from now on. The main switch does not need to be oper-

ated unless you are absent for a long time. It must only be operated while

the AMP III is in stand by mode.

Mains phase indicator

As mentioned above, your Audionet AMP III is able to detect a wrong

polarizing of the mains. The indication is done by the front LED between

the touch of the "power" ball and the "click" of the loudspeaker relays.

If the polarizing is correct, the LED flashes Ä_____Ä_____Ä etc.

However, if you should observe a fast signal Ä_Ä_Ä_Ä_Ä_Ä etc., flip

the plug in your wall outlet after having switched off the AMP III.

Audionet Link

When the AMP III is in stand-by mode its power can be controlled by any

Audionet preamplifier using the "Audionet link". This feature is de-

scribed in the preamplifier manuals, too.

You only need a simple optical "Toslink" cable. Connect one of the pre-

amplifier outputs "Audionet Link" with the "Link" input of your AMP III.

Now the AMP III power follows the preamplifier. Length of the "Tos-

link" cable is not critical - so you can place the AMP III next to the

speakers if you prefer!