Audionet PRE I G2 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Amplificador Audionet PRE I G2. Audionet PRE I G2 15 páginas. Stereo – pre - amplifier

Set display brightness

Set Autostart

Set Off_Text

1. Push the set button four times for at least one second. The display

changes to " Set Dim Value" .

2. The

brightness

OFF, 25%, 50%, 80%, 100% (Default brightness is 50%!)

3. To leave the programming mode, push the monitor/set a short time.

Alternatively you can proceed adjusting to the next step with another

long keypress (go on with (2) in this case):

If the display brightness is set to "OFF" the following is still displayed:

§ mute state

§ selecting a new input (displayed for approx. 3 seconds)

§ all programming

1. Push the set button five times for at least one second. The display

changes to " Set Autostart" . If autostart is set to "OFF" the PRE 1 G2

stays in the standby mode after switching on with the mains switch (3)

until the power button is pushed. If autostart is set to "ON" the PRE 1

G2 starts automatically into the on mode after switching on with the

mains switch (3). Select this option if you use a timer to control the

PRE 1 G2.

2. Select the autostart option by turning the volume knob.

3. To leave the programming mode, push the monitor/set a short time.

Alternatively you can proceed adjusting to the next step with another

long keypress (go on with (2) in this case):

1. Push the set button six times for at least one second. The display

changes to " Set Off_Text" .

2. Now you can choose the text to be displayed when your PRE 1 G2 is

in stand-by mode by turning the volume knob. The possible texts are:

"AUDIONET" or "¤¤".

Push the set button once again to finish programming.

Note:

If no changes are made for 10 seconds, your PRE 1 G2 will automati-

cally exit the programming menu.

can

adjusted

five

steps: