Danner 06402 Instrucciones de uso y mantenimiento - Página 2
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Bomba de agua Danner 06402. Danner 06402 2 páginas. Air pumps
Imprimir página
IMPORTANT SAFETY INSTRUCTIONS
To guard against injury, basic safety precautions
WARNING
should be observed, including the following:
A) READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER -
To avoid possible electric shock, special care should be taken since water is employed in the
use of aquarium and pond equipment. For each of the following situations, do not attempt
repairs by yourself; return the appliance to an authorized service facility for service or discard
the appliance.
I. If the appliance falls into the water, DON'T reach for it! First unplug it and then retrieve it. If
electrical components of the appliance get wet, unplug the appliance immediately.
II. Carefully examine the appliance after installation. It should not be plugged in if there is
water on parts not intended to be wet.
III. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or
has been dropped or damaged in any manner.
IV. To avoid the possibility of the appliance plug or
receptacle getting wet, position the aquarium stand and
tank to one side of a wall-mounted receptacle to prevent
water from dripping onto the receptacle or plug. A
"drip loop" shown in the gure below, should be
arranged by the user for each cord connecting an
aquarium appliance to a receptacle. The "drip loop" is
that part of the cord below the level of the receptacle, or the connector if an extension
cord is used, to prevent water from traveling along the cord and coming in contact with the
receptacle. If the plug or receptacle does get wet, DON'T unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the appliance. Then, unplug and examine for
the presence of water in the receptacle.
B). Close supervision is necessary when an appliance is used by or near children.
C). To avoid injury, do not contact moving parts or hot parts such as heater, re ectors, lamp
bulbs and the like.
D). Always unplug an applicance from an outlet when not in use. before putting on or taking o
parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect.
E). Do not use an appliance for other than intended use. The use of attachments not
recommended or sold by the appliance manufacturer may cause an unsafe condition.
F). Do not install or store the appliance where it will be exposed to the weather or
to temperature below freezing.
G). Make sure any appliance mounted on a tank is securely installed before operating it.
H). Read and observe all important notices on the appliance.
I). If an extension cord is necessary, a cord with a proper rating should be used. A cord rated
for less amperes or watts than the appliance rating may overheat. Care should be taken to
arrange the cord so that it will not be tripped over or pulled.
J). This appliance has a polarized plug (One blade is larger than the other). As a safety feature,
this plug will t in a polarized outlet only one way, If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact a quali ed electrician. Never use with an
extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature.
WATER
AIR PUMP
POWER
SUPPLY
CORD
DRIP
LOOP
2
K). This appliance has no user serviceable parts.
L). SAVE THESE INSTRUCTIONS
WARNING -
A). FOR INDOOR AND HOUSEHOLD USE ONLY.
B). TO PREVENT POSSIBLE ELECTRIC SHOCK RESULTING FROM WATER BACK
SIPHONING, PUMP SHOULD BE LOCATED HIGHER THAN WATER LEVEL.
WARNING -
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning the use of the of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
PUMP INSTALLATION AND OPERATION
TANK
Please read this operating instruction manual thoroughly and keep it for reference.
The pump is not designed to work submerged, so do not place the pump into water.
Always securely position the pump higher than water level. This will prevent water from
entering the pump housing through the air hose if power is interrupted.
Avoid sharp turns that can cause kinks in airline tubing as it may cause excessive back
pressure and decrease air flow.
The AP-4 and AP-8 are supplied with variable output control knob on the top of the
pump. The air output can be regulated by turning the control knob.
INCORRECT
CORRECT
CORRECT
Pump on tank
No Drip Loop
Pump
mounted
Drip Loop
Pump
on shelf
Drip Loop
3