Beldeko LENA 60 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación Beldeko LENA 60. Beldeko LENA 60 18 páginas.

6.1. Select the operation mode and place for installation of the extractor hood

6.2. Remove the extractor hood from the packaging.

6.3. Check the work of the extractor hood, connect it to the electric network and check all its functions.

6.4. To install the hood in the kitchen cabinet, make 4 holes with a diameter of 6-7 mm in the bottom shelf of

the cabinet according to pic. 5. Secure the hood with 4 M5x13 screws (Fig. 7).

6.5. In case of necessity install pipe to pipe adaptor for air duct (Ø150/120) and install air duct.

6.6. If the extractor hood is to be operated in an air-to-chimney mode, mount the air duct of the selected

diameter in accordance with the instructions, ensuring that it is tight.

6.7 If the hood will operate in recirculation mode, then the duct is not needed. A carbon odour-absorbing

filter (is purchased separately) must be installed.

6.8 Check that the hood is securely fastened, feed and connect the cord to the mains through the outlet.

In order to provide additional protection against power supply voltage swing, we recommend

connecting the hood through an additional 6A automatic switch.

7. INSTRUCTIONS FOR USE OF THE COOKER HOOD

7.1 The cooker hood has 2 speeds of ventilation. Depending on the amount of

evaporation during cooking, you can choose a low or high of ventilation level.

7.2 Before cooking, turn on the hood in the required operating mode. It is

recommended to continue work of the cooker hood for 3-5 minutes after

cooking, thus the air in the kitchen will be cleared from the residue of the vapours.

7.3. On the sides of the body there is a key switch for operating modes of the

engine and switching the lighting lamps (Pic. 8).

I speed (low speed) – press the switch to position "I"

II speed (average speed) – press the switch to position "II"

Рic.6

Рic.7

Рic.8