Addonics Technologies CDC5HXAES Manual - Página 3

Navegue en línea o descargue pdf Manual para Almacenamiento Addonics Technologies CDC5HXAES. Addonics Technologies CDC5HXAES 4 páginas.

Imprimir página

All settings on the diagram shows



RAID mode setting modification is ENAABLED (SET)



Error buzzer function is DISABLED (BZS)

Power on the Cipher Tower.

Verify if the RAID array is detected by the system

If the 5-port HPM-XA is connected to the motherboard onboard

SATA, on the CMOS setup utility, the raid array will display as

"Addonics H/W RAID5" if setup as a RAID5 array.

If the 5-port HPM-XA is connected to an eSATA host controller

card, on the RAID BIOS, the raid array will display as

"Addonics H/W RAID0" if setup as a RAID0 array.

If booted into Windows, in Disk Drives under Device Manager,

the raid array will display as "Addonics H/W LARGE" if setup as

a RAID0 array.

Once raid array is verified, you can set back the RAID jumper setting

back to default

or the diagram below where buzzer is ENABLED.

ADDONICS TECHNOLOGIES

Model: CDC5HXAES

Note: On this setting, there is no jumper on SET.

RAID Setting Notes:

Notes on Spare Drives

Using the Easy RAID Setting (EZ)

In reference to the diagram, the auto-rebuilding to spare drive is

ENABLED (EZ)

When EZ mode is ENABLED, the degraded RAID group will start

rebuilding automatically by using the existing spare drive.

* Spare drive can be either plugged before RAID building or a new drive

can be plug as the spare drive when RAID rebuild is required.

Which port acts as a spare drive?

The last drive will automatically become the spare drive.

For a 3-drive RAID5 with spare:

Drives connected to SATA ports 1~3 belong to the active RAID5 array

and drive connected to port 4 is the spare.

For a 4-drive RAID10 with spare:

Drives connected to SATA ports 1~4 belong to the active RAID10 array

and drive connected to port 5 is the spare.

For a 2-drive RAID1 with spare:

Drives connected to SATA ports 1& 4 belong to the active RAID1 array

and drive connected to port 5 is the spare.

When will rebuild action start?



When the raid fails and EZ is enabled, the HPM-XA will

automatically rebuild the RAID group using the spare.

When the raid fails and EZ is disabled, the HPM-XA will NOT rebuild the

raid group unless you install a good drive to replace the failed drive.

When 2 drives are connected to the

HPM-XA, and J4 is set to this setting,

the 2 drives will be configured as a

2-drive RAID1 array.

When 4 drives are connected to the

HPM-XA, the 4 drives will be

configured as a 4-drive RAID10 array.

Clone's action is similar to RAID1.

However, all of the hard drives will be

mirrored. Clone mode is useful

especially when users like to copy

data from a source hard drive to the

drives connected to the HPM-XA.