audiophony Wi SERIES Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Amplificador audiophony Wi SERIES. audiophony Wi SERIES 13 páginas. Professional stereo amplifiers

Imprimir página

ENGLISH

4.2 - Rear panel

[1] - Cooling fan

The air flow goes from the rear to the front and

lowers the temperature of internal components.

Never obstruct these vents and clean them on a

regular basis to make sure your device benefits from

the longest possible lifespan.

[2] - Combo input socket

This connector allows you to power up your

amplifier with a line-level signal. It is fully compatible

with both symmetrical and asymmetrical signals

but we recommend, whenever possible, to use

asymmetrical signals as it will help you getting rid of

parasitic noises when using low-quality cables. This

connector can also be used to connect Jack 6.35

TRS and male XLR plugs. Polarities are spread as

follows:

- Pin 2 (Tip) = Signal +

- Pin 3 (Ring) = Signal -

- Pin 1 (Sleeve) = Ground

[3] - Link connector

Allows you to send the incoming signal to another

amplifier.

[4] - HPF (High Pass Filter) switch

When "ON", the incoming signal is filtered.

Frequencies below 40 Hz are disposed of. This

function allows you to get rid of parasitic noises and

send a signal appropriate to the broadband of your

loudspeakers. When "OFF", a filter still eliminates

frequencies below 5 Hz to protect the input of your

amplifier against direct currents.

Page 6

Wi SERIES - Professional stereo amplifiers

2 3

4 5

7 8 9

[5] - Switch Limiter

Activates the "Limiter" function allowing you to

automatically reduce the sound level of excessive

signals and prevent them from being distorted.

[6] - Parallel / Stereo / Bridge Selector

Allows you to select the operating mode of your

amplifier:

- Stereo: Standard mode, each channel amplifies

the signal currently received.

- Parallel:The signal sent to input 1 is amplified in

a similar manner by both channels.

- Bridge: The two amplification channels are

added and only the input 1 signal is amplified.

[7] - Output via terminals

Allows you to connect speakers via a cable with

terminals plugs, or directly connect stripped cables.

In "Bridge" mode, use the red terminals to connect

your speaker.

[8] - Output via Speakon® connector

Allows you to connect speakers via a cable with

SpeakOn® connectors. More details about wiring

are available in next chapter.

[9] - Circuit breaker

Turns off the power supply in case of mains failure or

voltage overload. Press it again to reactivate it.

[10] - Power input

Connect here the supplied power cord to power up

your amplifier.