audiophony H10927 Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Mezclador de música audiophony H10927. audiophony H10927 17 páginas.

Imprimir página
audiophony H10927 Manual del usuario
Français
5 - Presentation

Front pannel

1
6
1
Potentiomètre REMOTE MIC
Determine the signal level from remote microphones for
each channel.
2
PAGING MIC Potentiometer
Adjusts the signal level from the announcement
microphone for each channel.
3
WALL CTRL selector
3
2
Enable control of the corresponding channel via a WS8
or WP8 wall controller. When this selector is activated
the button is lit and the channel control is fully supported
by the WS8 or WP8. These switches flash when a wall
controller is connected to the area.
4
Digits
14
Specify the selected output zone for each input.
5
BGM SELECT selector
These selectors are used to assign the announcement
microphones to one or more channels.
6
Zone potentiometer
5
15
These potentiometers allow you to adjust the level of
each channel.
If a wall controller such as the WS8 or WP8 is active on
the channel, this potentiometer is disabled.
7
Vu-metter LEDs
These LEDs indicate the presence of a signal and the
level of this signal.
8
MONITOR potentiometer
This potentiometer adjusts the preview level of the
channel selected by the BGM SELECT button above.
The channel selected for preview is displayed above the
button mentioned above.
Page 12
2
3
4
5
7
1
4
7
16
MX82 - Mixer/Préampli multizone rackable avec 8 entrées et 2 sorties
12
13
8
9
MONITOR SPEAKER
Pre-listening loudspeaker.
10
PAGING MIC input
XLR plug for connecting an announcement microphone.
11
PAGING MIC volume
Adjusts the level of the announcement microphone.
6
8
12
TALK button
Allows you to broadcast an announcement. This requires
that at least one zone is selected.
13
ALL button
Allows you to select all zones.
14
Zone buttons
These buttons are used to select the zones on which you
want to broadcast an ad. When the area is selected, the
corresponding button is lit. To de-select the zone, press
the corresponding button again, the button turns off.
13
10
15
REC button
This button is used to record an alert message. This
message is recorded via the PAGING MIC microphone
on the front panel (10).
To access the recording process, press and hold the
REC button until it lights up red. The digits then display:
To start recording, hold this key again, the two digits at
the ends rotate clockwise, as shown below:
To stop recording, briefly press the REC button.
14
15
11
10
16
9
9
11
17
18
12