Dansing Wings SCG37 Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Juguete Dansing Wings SCG37. Dansing Wings SCG37 8 páginas.
Imprimir página03-5
03-6
上机翼中间件
upper wing middle parts
上机翼
03-7
03-8
upper wing
Epoxy glue
X01
x2
在上一步骤胶水未干前 ，按上图把机翼和中间连接件装到一起，并用螺丝把X01固定住，并把接处
03-9
的缝隙调整到最小。待胶水干后可先拆下机翼方便后续安装。
Before the glue in the previous step is dry, install the wing and the intermediate connector
下机翼
together according to the above figure, fix X01 with screws, and adjust the gap at the joint
lower wing
to the minimum. After the glue is dry, the wing can be removed for subsequent installa-
tion.
Epoxy glue
03-10
x2
X01
按步骤03-8方法进行安装。待胶水干后可先拆下机翼方便后续安装。
Install according to step 03-8. After the glue is dry, the wing can be
removed for subsequent installation.
5
03-11
在副翼预留槽内安装舵角，在舵机
臂上安装快装接头。把连杆夹头一
端夹住舵角，另一端穿入快装接头
并锁定。
Install the rudder horn in the
reserve slot of the aileron,and
install the EZ-connector onto the
servo arm.Clamp one end of the
connecting rod to the rudder
horn and insert the other end
into the EZ-connector and lock
it.
在上机翼中间件上安装支架，用螺
丝锁定。
把中间连接安到机身，并注意几处螺丝的安装。
Install the bracket on the upper
wing middle parts and lock it
Install the middle connection to the fuselage, and pay attention
with screws.
to the installation of several screws.
自攻螺丝
Self-tapping screw
M3x10mm
03-12
螺丝 Screw
M3x12mm
在上图位置插入碳杆。
Insert the carbon rod in the position shown above.
细节1
Detail 1
螺丝 Screw
M3x30mm
螺丝 Screw+螺母 Nut
M2*11mm
03-13
碳杆
carbon rod
Ø10*665mm
碳杆
carbon rod
Ø10*455mm
上下机翼对插到碳杆上。注意几处固定细节。
Insert the upper and lower wings into the carbon
rods. Pls take care of some fixed details.
螺丝 Screw
*
M3
18mm
螺丝 Screw
M3x12mm
6