Audiopipe APK-3500 Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Amplificador Audiopipe APK-3500. Audiopipe APK-3500 12 páginas. Sound quality amplifier
Imprimir página
GAIN ( 6V ~ 0.2V )
Used to reach maximum amplifier
power by matching the output
voltage of with a wide variety of
the headunits
SUBSONIC FILTER ( 10~50HZ @ 24dB )
Control the high pass frequency for
the speaker outputs to eliminate
extreme low frequencies.
Subsonic is always on with a 24dB
per octave slope.
BASS BOOST ( 0 ~ 9dB )
The bass boost boosts frequency
centered at 45Hz.
MASTER / SLAVE ( STRAPPABLE )
4-2. FULL RANGE 2CHANNEL
RCA INPUT & OUTPUT
RCA INPUT :
Connect preamp signal cables
from the source or the
headunit to RCA input
RCA OUTPUT :
Output RCA jack to another
amplifier.
Output master / input slave connection makes 2 amplifiers strapped to 2ohm
Set Output master / input slave switch to output master position for Master amp
which is connected to headunit.
Set Output master / input slave switch to input slave position for Slave amplifier
Connect RCA cable from master amplifier to slave amplifier.
Output master / input slave connection impedance is 2ohm.
REMOTE PORT
This port is for remote level control.
Plug remote control's connector for
remote level control's use.
Remote controls level from
the driver's seat.
LOW PASS FILTER ( 35~250HZ @24dB )
Controls the low pass filter frequency
for the speaker output.
The Low pass filter is always on with
24dB per octave slope.
PHASE ( 0~180 DEGREE )
Controls phase 0~180 degrees for fine
tunning your low end staging in your
vehicle or fully switching polarity
if inverting your woofers.
GAIN ( 6V ~ 0.2V )
Used to reach maximum amplifier
power by matching the output
voltage of with a wide variety of
the headunits