Audioplex INW-8 Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Interruptor Audioplex INW-8. Audioplex INW-8 8 páginas. In-wall stereo switcher

Power:

Transformers rated at 200 Watts RMS continuous (600 Watts audio) 35Hz-20kHz

Load:

Match up to 8 pairs of 4 or 8 Ohm speakers with all on simultaneously.*

Mounting:

Mud rings must be used with installation. The out board transformers fit into standard wall Space.

Connections:

Wago connectors.

*For amplifiers requiring a load of 8 Ohms or higher you must adjust tap settings to X16 when using more than 4 sets

of 4 or 6 Ohm speakers.

The INW-8 switches up to 8 pairs of 4, 8 Ohm or higher impedance speakers in any

combination, while maintaining a safe load to the amplifier. The load protection is achieved by use of an impedance

matching transformer, which offers several significant advantages. There is little or no heat developed whether one

or all the speakers are operating simultaneously, so no fire hazard exists with the in-wall switcher.

The INW-8 is supplied with two impedance matching jumpers that are normally connected to the X8 position,

which multiplies the speaker impedance to 8 times the nominal value. Thus if 8 pairs of 4 Ohm speakers are

switched on at the same time, the parallel impedance load would be .50 Ohms. The transformer setting multiplies

the impedance by 8, so the total load to the amplifier appears as 4 Ohms. The jumper settings can be adjusted to

accommodate different situations.

Insert a screwdriver into the Wago connector with a rocking motion to the stop. The screwdriver is captivated,

holding the cage-clamp open, while the wire is inserted. The screwdriver is withdrawn and the wire is

automatically clamped.

Your AUDIOPLEX TECHNOLOGY INW-8 Series Speaker Selector is covered by a Lifetime

warranty against any defects in workmanship and materials. Any defects will be remedied without

charge for labor or parts.

Damage incurred by shipping or accident is not considered to be a defect, and not covered by this

warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused by abuse or

by modification or service by any unauthorized person or agency.

The unit must be properly installed and operated according to instructions for the warranty to apply.

Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The unit must be returned

expenses prepaid, with written authorization from the company. The product must be shipped with the

proof of purchase and in the original carton and packing material to avoid damage. This warranty gives

you specific legal rights. You may have other rights which vary from state to state.

INSTALLATION MANUAL

TECHNOLOGY

INW-8

IN-WALL STEREO SWITCHER

GENERAL INFORMATION

IMPORTANT

WIRING

WARRANTY

2000 - 6/22/00