Audioplex RackIt IR Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Amplificador Audioplex RackIt IR. Audioplex RackIt IR 1 páginas. Audioplex rackit ir ir distribution system: install guide

Imprimir página
Connectors:
Screw-type
Emitter outputs:
1/8" mini-jack, five on front, one on rear
Power supply:
+12vdc power supply (included)
Dimensions:
1.75"H x 19"W x 1.25"D
The RackIt IR provides a convenient rack mounted connecting point for a remote relay system, eliminating hard-wiring. Each room
has its own screw-down connector for the IRTarget, each emitter and power supply has its own plug-in jack. The enclosed IRDirect
emitters work in conjunction with the IRPrisms (see enclosed insert), and allow full rotation to direct the IR signal towards the
IRPrism and the intended component. IRBugs and IRfloods can also be used and are sold separately. Follow the wiring diagram
below for basic set up.
The RackIt IR includes a jack for an optional 12vdc wall adapter. By plugging the adapter into your receiver's switched AC outlet, you
will provide SYS-TAT power whenever the receiver is turned on.
IN-WALL
IR TARGET
Your AUDIOPLEX TECHNOLOGY RackIt IR is covered by a LIFETIME WARRANTY against any defects in
workmanship and materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY is not responsible for defective operation caused by abuse or by modification or service by any unauthorized person
or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary servicing
must be done by AUDIOPLEX TECHNOLOGY. The product must be returned expenses prepaid, with written authorization from the
company. The product must be shipped with the proof of purchase and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
1-800-257-2077 IN NH 1-603-544-8601 FAX: 1-603-544-8901
INSTALLATION MANUAL
Rack Mounted Termination point for IR repeating systems
SPECIFICATIONS
WIRING DIAGRAM
POWER
RED 12V (B+)
BLACK (G)
GRAY (S)
YELLOW (unused)
WHITE (unused)
AUDIOPLEX TECHNOLOGY
404 GWH PO BOX 440
www.audioplex.com
TECHNOLOGY
RACKIT IR
BACK VIEW
SYS-TAT
(optional)
EMITTER
POWER
FRONT VIEW
WARRANTY
MELVIN VILLAGE, NH 03850
DX
12V POWER
V
GROUND
G
SIGNAL
S
STATUS (optional)
T
Direction
of IR signal
The new IRDirect rotates 360
allowing you to "aim the IR
signal" towards the intended
piece of equipment.
TECHNOLOGY
2003 - 5/6/03