Constellation audio Inspiration PREAMP 1.0 Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Amplificador Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 páginas.
También para Constellation audio Inspiration PREAMP 1.0: Manual del usuario (16 páginas)
Imprimir páginaBefore you install the PREAMP 1.0
Unpacking
Because of its machined aluminum top chassis, the PREAMP 1.0 is heavier than the average preamp.
Have an extra person nearby to help if you need it. You may wish to use gloves to protect your fingers.
NOTE: Prior to plugging in the PREAMP 1.0, loosen the inner black 5/32" hex shipping set screws
near the feet by four turns.
Installation notes
If you will be using the Constellation Audio Inspiration MONO 1.0, STEREO 1.0, Centaur or Hercules
amplifier (or any other high-powered amplifier), we recommend you do not plug the PREAMP 1.0 into
the same AC socket or into any other outlet connected on that circuit. Constellation Audio amplifiers
draw a great deal of power and could affect the PREAMP 1.0's performance if the amplifier(s) and
preamp are plugged into the same electrical circuit or AC outlet.
When you connect or disconnect the AC cord, always grasp it by the plug, not by the cord itself. Pulling
the plug out by the cord can damage the cord, the AC socket, and/or the PREAMP 1.0.
The PREAMP 1.0lifier uses passive cooling; there are no internal fans. While the PREAMP 1.0 does not
generate as much heat as an amplifier, it should still be located in an area with adequate ventilation.
There should be at least 6 in/15 cm of clearance between the sides and top of the preamp and the
nearest wall or cabinet. If the PREAMP 1.0 is installed in a cabinet or an equipment closet, ensure the
cabinet/closet has adequate ventilation. Installation in an unventilated cabinet or closet may cause the
PREAMP 1.0 to overheat, significantly reducing its lifespan.
The PREAMP 1.0 requires a room-temperature environment to operation properly. Ambient
temperature should be about 70°F/21°C, plus or minus 10°F/5°C. Never install the PREAMP 1.0 in a
place where it may be exposed to direct sunlight, and do not install it next to a room heater, radiator,
air conditioner, etc.
Make sure that the PREAMP 1.0 will not be exposed to moisture. Do not locate it in an area where it
might be spilled on, and do not place it in a humid location (such as an unfinished basement).
We recommend leaving the PREAMP 1.0 on all the time. This way, it will always be at its optimum
operating temperature and will always achieve maximum performance.
Installing the PREAMP 1.0 in a place where it will be exposed to direct sunlight or moisture, or where it
will not have adequate ventilation, will void your warranty.
Amplifier note
The PREAMP 1.0 is designed to be paired with any high-quality audio amplifier; ideally Constellation's
own Inspiration MONO 1.0, STEREO 1.0, Centaur or Hercules amps. Both balanced (XLR) and unbalanced
(RCA) connections are available. XLR will provide the highest quality/lowest noise signals, and should
be used when possible.
4