Constellation audio Inspiration PREAMP 1.0 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Amplificador Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 páginas.
También para Constellation audio Inspiration PREAMP 1.0: Manual del usuario (16 páginas)
Imprimir página4. Speaker-cable binding posts
On the Inspiration MONO 1.0, two sets of
binding posts are provided for each amp's
output. These can be used for standard
cabling (with a two-conductor cable
running from the amp to the speaker) or
in a bi-wired arrangement with separate
cables going from one amp to the
speaker's woofer and midrange/tweeter
Inspiration MONO 1.0 binding post layout
drivers. Consult your speaker's manual
for more information. On the Inspiration
STEREO 1.0, one set of binding posts is
provided for each channel.
Connect the marked connector or cable
conductor for the left speaker cable to the
left positive (+ or red) binding post and
the unmarked connector to the negative (-
or black) binding post underneath.
Inspiration STEREO 1.0 binding post layout
Repeat with the right speaker cable.
Make sure the speaker cables on both
channels are connected identically—marked cable conductor or connector to red, unmarked conductor or
connector to black. Note that on the Inspiration MONO 1.0, the positive (+ or red) terminals are on the left
side, seen from the rear) and the negative terminals (- or black) are on the right side.
The binding posts accept spade lugs or banana plugs. Make certain that the spade lugs on your cables will fit
the amplifier's binding posts—do not force the spade lugs onto the posts if they do not fit. Do not use bare
wire connections, because the amplifiers' high power output might vaporize any stray wires that touch. The
binding posts are designed to be tightened only by hand. Do not use tools to tighten the binding posts.
To connect banana plugs, remove the threaded cap from the binding post entirely by twisting it
counterclockwise, then insert the banana plugs into the sockets at the ends of the posts.
Before you turn on the power, check at the terminals of the speakers and the amplifier to make sure the
positive and negative leads of the speaker cables are separated and not touching.
7