Danver 1300 CFM DOHC Series Instrucciones de instalación y manual de uso y mantenimiento - Página 9

Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación Danver 1300 CFM DOHC Series. Danver 1300 CFM DOHC Series 12 páginas.

Imprimir página

PART 3: Determining Direction of Vent and Securing the Hood

Mounting Holes:

Because the DANVER® DOHC Series Range Hood was designed for all applications, no mounting holes have been

pre-drilled. This allows for custom applications for mounting. The hood should be attached to the framing

through the top and back, whenever possible. Remove the filters. Mark and drill screw holes through the hood

as required. Secure the hood by driving screws (provided by others) through the screw holes.

NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES TITANIUM DRILL BITS. BE CAREFUL

NOT TO DRILL THROUGH THE UL LABEL OR INTO THE HOOD'S ELECTRICAL COMPONENTS.

Duct Cover:

Detail A

Drill 5/32" holes and install 4 brackets on hood with screws supplied.

•

Mount 2 brackets to wall using customer supplied hardware. Centerline of holes is 2" less than width of

hood, so a 36" hood has a 34" hole spacing.

•

Install Duct Cover over brackets.

Item #

OBL-00-008

Rev. 10-2017