DanVex AD-10000 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Deshumidificador DanVex AD-10000. DanVex AD-10000 18 páginas. Adsorption air dehumidifier

Imprimir página

Introduction

This specification is a technical document that certifies the DanVex AD-10000 dehumidifier

parameters and characteristics.

Purpose

DanVex AD-10000 (in short AD-10000) is designed for efficient air dehumidification with the air

humidity up to 100%, at the temperature from –20ºС to +40ºС with minimum energy

consumption. It can be used either as an independent unit for installation inside and outside of

premises where air humidity control is required or along with an air treatment system.

Operation principal

The main dehumidifier part is a rotor having a cellular structure made from fibrous ceramic

material and SelicaGel. The rotor is divided into two zones by a sealing device: one for

dehumidification, another for regeneration.

Thus, the dehumidifier works with two air flows. The volume of the dehumidified air is bigger. The

air flow of a smaller volume is used for moisture removal from the dehumidifier rotor. The rotor is

subject to the action of different oppositely directed air flows by sectors. The air flow to be

dehumidified (PROCESS AIR) passes through the biggest sector. The moisture from the air is

trapped (adsorbed) by the rotor material. The air leaves the rotor in dehumidified condition (DRY

AIR) and is directed to a certain part of the building or a technological process where

dehumidified air or a certain air humidity levels are required. Since the rotor rotates slowly the

incoming air always contacts with the rotor active part, thus a continuous dehumidification

process is assured.

The air flow used for the rotor regeneration is called regeneration air (REGENERATION AIR). It is

heated up to 140 С and when passing through a small sector it removes the moisture trapped by

the rotor material. The moisture is removed from the rotor in the form of humid air (MOIST AIR)

which is discharged outside the dehumidified loop

Process air

Process air fan

Filter

Moist air

The air to be dehumidified passes through the rotor. Water molecules are absorbed by the rotor.

The rotor is reactivated by another air flow preheated to 140 C. The moisture is removed from the room

in the form of moist air.

www.danvex.fi

Adsorption rotor

Rotor motor

Pic.1. Dehumidifier air flows diagram

Dry air

Regeneration air fan

Heater

Filter

Regeneration air