DanVex DEH-600wp Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Deshumidificador DanVex DEH-600wp. DanVex DEH-600wp 18 páginas.

INSTALLATION NOTE

Before installation of the dehumidifier:

Before shipment from the factory all the dehumidifiers are subject to tests. Unpack the box

and check for damage on the surface of the device, as well as for completeness of

components in accordance with the list specified in the instructions. If You find any damage,

do not attempt to install the humidifier and immediately contact the supplier.

IF DURING TRANSPORT THE DRYER WAS LYING ON THE SIDE, IT NEEDS

TO BE LEFT UPRIGHT FOR AT LEAST 24 HOURS BEFORE THE START OF

(failure to perform this may cause damage to the dryer and void your warranty)

Installation diagram.

In case of indoor installation of the device, provide availability of free space for its

maintenance. The premises, where the device is installed, must be ventilated.

Mounting of the dehumidifier on the wall:

Step 1: Select the correct position for mounting on the wall, depending on the size of the

holes set and the holes positions of the wall mount bracket. The place of installation should

guarantee the vertical position of the dehumidifier. Mark places for drilling.

Step 2: Use hammer drills to drill holes with depth of 8 ± 0.5 cm Then use the anchor bolts

and install them into the holes with a hammer.

Step 3: Install the wall bracket with anchor bolts in the correct position. Please, provide

secure fixing of the bracket using nuts and washers. Don't forget to hold the bracket in the

correct position during installation.

Step 4: Install the dryer on the wall bracket.

Step 5: Connect the drain hose to the dehumidifier. Turn on the dehumidifier for trial use.

Check the device for presence of abnormal vibration and noise.

Step 6: Installation is finished and the dehumidifier is ready for use.

www.danvex.fi

ITS OPERATION!!!

CAUTION!!!