CONTACLIP EMS-eco Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Plotter CONTACLIP EMS-eco. CONTACLIP EMS-eco 16 páginas. Easy-marking-system

Stop/view key

If the 'stop/view' key is activated while the plotter is in action, the job will pause

immediately and the plotter pen will move into the top right-hand corner. The red light

will signal the interruption. Pressing the key again will calibrate the writing arm and the

plotter will continue with the job. The red light will go out.

Beep off key

After completion of the print job an acoustic signal (beep) will notify the user to take

the pen out of the pen holder and re-cap. The signal will be repeated continuously

after 20 seconds and can be turned off by using the 'beep off' key.

Attention:

The pen will clog and dry up if it remains un-capped in the pen holder.

Please note:

To turn off the signal in general please press 'Clear buffer' and 'beep off' together and

press 'ON' to start the plotter.

To re-activate the signal please use the same sequence.

Insert the plotter pen into the pen holder

Before using the EMS-eco, insert the plotter pen with the desired tip width into the clip

adapter of the pen holder.

Important:

Only plotter pens of the types shown with HP-adaption

may be used. Using other plotter pens and writing

instruments may damage the device.

Please note:

Prior to starting the plot, please select the pen with the desired tip width and make

sure to prime the pen on a plastic surface. Insert the pen directly into the pen holder.

The plotter always re-calibrates prior to first plotting.