DAONE DW101 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Cafetera DAONE DW101. DAONE DW101 6 páginas.

Imprimir página
Successful Installation
Damages resulting from improper installation are not covered by the warranty.
Here are the key points to consider before installation.

Electrical Connection

1.Verify that the actual voltage at the electrical service connection is compatible with the specifications on the
coffee maker's label.
All
Cofman coffee makers
Installation without neutral may cause the electronic components to damage.
2. Pour water of about
2 liter
Because, at first if you supply electricity for it, inside the tank is empty, Heater is damaged.
3. Power cords and plugs are shipped your national electrical configurations.
Coffee Maker
(DW101) S
1. Fill water of about
2
liter into the
2. Turn on the incoming power.
3. Turn on the
coffee
maker's main power switch.
4. Heater operates and Heating Lamp is lighted.
5. The
coffee maker
will be stand-by for operation as soon as the stand-by light comes on to signify that the
water tank is up to temperature.

Troubleshooting

PROBLEM
Shot brew levels (Every Brew)
Affected and levels are consistent.
Brew water is cold /
not hot enough,
Stand-by light is OFF.
Brew water is cold /
not hot enough,
Stand-by light is ON.
Slower to recover temperature
Boiling

Installation

require NEUTRAL. Ground is not an acceptable substitute.
into the
Coffee Makers
(DW101),
etup
coffee maker
(DW101)
POSSIBME CAUSE
Spray-cap clogged
Put waste (coffee powder) on inside.
No power to brewer
Bad heater element
Bad Thermostat (the thermostat
belive that it is at set temperature)
Low brew temperature setting on EGO.
Water tank limed up
Thermostat set too high for altitude
Defective thermostat (EGO)
DW 101 - Installation
then, electricity to concert.
Clean and replace the spray-cap
After dissolution, inside cleaning
- Make sure power switch is on.
- Check power connection.
(plug or hard wire)
- Check building circuit breaker
Check amperage draw on heater wires.
Change the new Thermostat
Adjust thermostat (88~90℃)
Check amperage and inspect for lime.
Reduce temperature setting to 5℃ below
Replace the thermostat
DW 101
01 . 60
SOLUTION